This does not indicate a malfunction.
Outside air circulation:
Manual operation
Push the air intake button to draw the air flow from
The manual mode can be used to control the heater
and air conditioner to your desired settings.
Heating (A/C off):
outside the vehicle. (The indicator light on the “
side will illuminate.)
”
1. Push the “AUTO” button.
To turn off the heater and air conditioner, push the
“OFF” button.
2. If the “A/C” indicator light illuminates, push the
“A/C” button.
Air recirculation:
Push the air intake button to circulate the air flow inside
.
While the “Drive Mode” is indicated on the screen,
adjusting the amount of airflow and controlling the
airflow direction are not possible. Push the
“CLIMATE” button to change to the “Climate
Control mode”.
3. Turn the temperature control dial to set the desired
temperature.
the vehicle. (The indicator light on the “
illuminate.)
” side will
.
Do not set the temperature lower than the outside
air temperature. Doing so may cause the tem-
perature to not be controlled properly.
Automatic air intake control:
Push the air intake button for approximately 2 seconds.
The indicator lights (both air recirculation and outside
air circulation sides) will blink twice, and then the
intake air will be controlled automatically. The auto-
matic control is set between the outside air circulation
Fan speed control:
.
If the windows fog up, use dehumidified heating
instead of the A/C off heating.
Turn the “
” fan speed control dial clockwise (+) or
counterclockwise (−) to manually control the fan
speed.
Dehumidified defrosting/defogging:
1. Push the front defogger
” indicator light will illuminate.)
“
”
button. (The
“
”
and air recirculation
“
”
modes (the
Push the “AUTO” button to change the fan speed to
the automatic mode.
“
indicator light of the side that is operating will
illuminate).
2. Turn the temperature control dial to set the desired
temperature.
Air flow control:
Setting climate ECO
When the Drive Mode is displayed, you can set
CLIMATE ECO ON or OFF.
Push the corresponding air flow control button to set
the air outlet to the preferred mode.
.
To remove frost from the outside surface of the
windshield quickly, set the temperature to a high
temperature and the fan speed to the maximum
level.
—
Air flows from the center and side
ventilators.
(See “ECO drive mode” (P.5-17).)
—
Air flows from the center and side
ventilators and foot outlets.
.
.
After the windshield is cleared, push the front
SERVICING AIR CONDITIONER
defogger “
” button again. (The indicator light
will turn off.)
—
—
Air flows mainly from the foot outlets
WARNING:
When the front defogger “
” button is pushed,
Air flows from the defogger outlets and
foot outlets.
The air conditioner system contains refrigerant
under high pressure. To avoid personal injury,
any air conditioner service should be done only
by an experienced technician with the proper
equipment.
the air conditioner will automatically turn on to
defog the windshield. The air recirculation mode
will automatically turn off. The outside air circula-
Temperature control:
Turn the temperature control dial to set the desired
temperature.
tion mode “
” will be selected to improve the
defogging performance.
The air conditioner system in your vehicle is charged
with a refrigerant designed with the environment in
mind.
This refrigerant will not harm the earth’s ozone
4-14 Heater and air conditioner, and audio system
English 
