INTERIOR LIGHTS
Depending on the environment or driving conditions,
the auto reverse function may be activated if an impact
or load similar to something being caught in the
sunroof occurs.
Sunshade
CAUTION:
To open or close the sunshade, slide the sunshade
manually.
.
.
Do not leave the light switch on when the
engine is not running for extended periods
of time to prevent the battery from being
discharged.
The sunshade will open automatically when the
sunroof is opened. The sunshade needs to be closed
manually by sliding it.
If sunroof does not operate
If the sunroof does not operate properly, perform the
following procedure to initialize the sunroof operation
system.
Turn off the lights when you leave the
vehicle.
Sunroof
Tilting:
1. If the sunroof is open, close it fully by repeatedly
MAP LIGHTS
To tilt up, first close the sunroof by pushing the switch
toward
again and release it; it need not be held. To tilt down
the sunroof, push the switch toward
2
*
pushing the switch toward
.
2
*
2
*
. Push the switch toward
2
*
2. Push and hold the switch toward
the sunroof up.
to tilt
1
*
.
3. Release the sunroof switch after the sunroof
moves slightly up and down.
Sliding:
To fully open or close the sunroof, push the switch
1
4. Push and hold the switch toward
tilt the sunroof down.
to fully
*
1
2
toward
or
and release it; it need not
*
*
be held. The roof will automatically open or close all the
way. To stop the roof, push the switch in any direction
while it is opening or closing.
5. Check if the sunroof switch operates normally.
If the sunroof does not operate properly after perform-
ing the procedure above, have your vehicle checked by
a NISSAN dealer.
SIC4572
Auto reverse function
Operate the map light switch to turn the map light on
or off.
WARNING:
There is a small distance just before the closed
position which cannot be detected. Make sure
that all passengers have their hands, etc. inside
the vehicle before closing the sunroof.
1
: ON position
*
2
*
: OFF position
The auto reverse function can be activated when the
sunroof is closed by automatic operation when the
ignition switch is in the “ON” position. If the control unit
detects something caught in the sunroof when it is
closing, the sunroof will be immediately opened.
If the sunroof cannot be closed automatically when the
auto reverse function activates due to a malfunction,
2
*
push and hold the switch toward
.
2-34 Instruments and controls