Driving
– The outside temperature must be between
0°C and 35°C.
After the engine has restarted, STOP
mode is not available until the vehicle
has reached a speed of 5 mph (8 km/h).
In these cases, this indicator lamp flashes
for a few seconds, then goes off.
6
Putting the engine into standby
(STOP mode)
The engine automatically enters standby mode
as soon as the driver indicates their intention to
stop:
– With a manual gearbox: with the gear lever
in neutral and the clutch pedal released.
– With an automatic gearbox: with the gear
selector in mode D or M, the brake pedal
depressed until the vehicle stops or the gear
selector in mode N, with the vehicle stationary.
Malfunctions
In the event of a fault with the system, this
warning lamp flashes for a few moments
on the instrument panel, then remains on,
accompanied by the display of a message.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
During parking manoeuvres, STOP mode
is not available for a few seconds after
coming out of reverse gear or turning the
steering wheel.
Restarting the engine (START mode)
The vehicle stalls in STOP mode
The engine automatically restarts as soon as the
driver indicates the intention of moving off again:
With a manual gearbox: with the clutch pedal
fully depressed.
All of the instrument panel warning lamps come
on if there is a fault.
► Switch off the ignition then start the engine
again with the key or the "START/STOP" button.
Time counter
With an automatic gearbox:
A time counter adds up the time spent in standby
during the journey. It is reset to zero every time
the ignition is switched on.
– With the selector in mode D or M: with the
brake pedal released.
12 V battery
The Stop & Start system requires a
12 V battery of specific technology and
specification.
All work must be carried out only by a
PEUGEOT dealer or a qualified workshop
– With the selector in mode N and the brake
pedal released: with the selector at D or M.
– With the selector in mode P and the brake
pedal depressed: with the selector at R, N, D
or M.
Special cases:
The engine will not go into standby if the
conditions for operation are not met and in the
following cases:
– With reverse gear engaged.
– Steep slope (ascending or descending).
– Vehicle has not exceeded 6 mph (10 km/h)
since the last engine start (with the key or the
START/STOP button).
– Needed to maintain a comfortable temperature
in the passenger compartment.
Tyre under-inflation
detection
This system alerts the driver when one or more
tyres have a drop in pressure.
The alert is raised when the vehicle is moving,
not when stationary.
It compares the information given by the wheel
speed sensors with reference values, which
Special cases
The engine will restart automatically if the
conditions for operation are met again and in the
following cases:
– With a manual gearbox: vehicle speed
exceeds 2.5 mph (4 km/h).
– Demisting active.
In these cases, this indicator lamp flashes
for a few seconds, then goes off.
– With an automatic gearbox, in mode N, vehicle
speed exceeds 0.6 mph (1 km/h).
111
English 