Get Driving -> Visiopark 2 Guide for Peugeot 308 4 Door 2021-2025

Driving

Obstacles may appear further away than

Panoramic view

they actually are.

It is important to monitor the sides of the

vehicle during the manoeuvre, using the

mirrors.

Parking sensors also provide additional

information about the area around the vehicle.

The panoramic view allows you to leave, in

reverse, a parking space by anticipating the

arrival of vehicles, pedestrians or cyclists.

This view is not recommended for carrying out a

complete manoeuvre.

Standard view

The screen is divided into 4 parts with two side

menus, a contextual view and a view from above

the vehicle in its close surroundings.

The parking sensors supplement the information

in the view from above the vehicle.

Depending on the view angle chosen in the

left-hand side menu, the system provides

speciﬁc visual assistance in particular driving

conditions, such as entering a blind intersection

or manoeuvring in areas with reduced visibility.

Diﬀerent contextual views are available for the

rear or for the front:

This view is only available by selection in the

side menu.

The area behind the vehicle is displayed on the

screen.

The blue lines 1 represent the width of your

vehicle, with the mirrors unfolded; their direction

changes according to the position of the steering

wheel.

Visiopark 2

For more information, refer to the

General recommendations on the use

of driving and manoeuvring aids.

This system allows you to view your vehicle's

close surroundings on the touch screen using

cameras, located at the front and rear of the

vehicle, as well as under the door mirrors.

The red line 2 represents a distance of 30 cm

from the rear bumper; the two blue lines 3 and 4

represent 1 m and 2 m, respectively.

This view is available automatically or by

selection in the side menu.

– Automatic zoom view.

– Standard view.

– Panoramic view.

Depending on the context, the system chooses

the best view to display (standard or automatic

zoom).

The view type can be changed at any time

during the manoeuvre.

The system status is not saved when the ignition

is switched oﬀ.

146

Driving

Operating principle

Reconstructed view

Settings

Automatic zoom view

In the side menu, this menu allows you to

carry out the following operations:

– adjust the volume of the audible signal.

– adjust the brightness.

The cameras are activated and a reconstruction

of a view from above your vehicle in its close

surroundings is displayed on the touch screen.

– adjust the contrast.

Live view

Activation/Deactivation

Automatic

The front or rear camera records the

surroundings during the manoeuvre to create

a front or rear view from above the vehicle in

its close surroundings, making it possible to

manoeuvre the vehicle around the surrounding

obstacles.

Using the sensors located on the front or

rear bumper, the automatic zoom view is

displayed when approaching an obstacle at the

red line (less than 30 cm) during the manoeuvre.

This view is only available automatically.

Depending on version, it can be activated/

deactivated in the ADAS application of the touch

screen.

With the rear camera, engine running and

vehicle stationary, rear vision is displayed

automatically if reverse gear is engaged.

With the front camera, engine running and speed

below 10 mph (16 km/h), front vision is displayed

automatically if a gear is engaged.

The front, rear and side views automatically

appear in the view from above the vehicle.

It is also possible to display any live view by

selecting the corresponding zone.

The front view can be selected in forward gear

up to 10 mph (16 km/h).

Manual

► In the ADAS touch screen application,

select Functions>Panoramic camera

The system is deactivated:

– automatically for the rear, when changing out

of reverse gear.

Installing the very cold climate screen

can alter the image transmitted by the

front camera.

– automatically for the front, above

approximately 10 mph (16 km/h).

– by pressing the cross in the top left-hand

corner of the touch screen.

Obstacles may appear further away than

they actually are.

It is important to monitor the sides of the

vehicle during the manoeuvre, using the

mirrors.

An additional jet is ﬁtted above the number plate

to clean the reversing camera (depending on

version).

► The washing of the reversing camera is

triggered by operating the rear screenwash.

Parking sensors also provide additional

information about the area around the vehicle.

147

Driving

This view is not recommended for carrying out a

complete manoeuvre.

Standard view

This view is only available by selection in the left-

hand side menu.

Side views

The left-hand/right-hand side view allows you to

view the surroundings of each side of the vehicle

(e.g. pavement, low wall, other vehicle parked

next to it).

Depending on the context, the area behind or in

front of your vehicle is displayed on the screen.

The blue lines (at the rear)/orange lines (at the

front) 1 represent the width of your vehicle, with

the mirrors unfolded; their direction changes

according to the position of the steering wheel.

The red line 2 represents a distance of 30 cm

from the rear or front bumper; the two blue lines

(at the rear)/orange lines (at the front) 3 and

4 represent 1 m and 2 m respectively.

When engaging reverse gear with the engine

running, or when reversing at up to 6 mph

(10 km/h), this system warns of approaching

obstacles (e.g. pedestrian, cyclist, vehicle, truck,

motorcycle) in the blind spots of the vehicle,

using the radars installed in the bumper.

The system detects obstacles moving at

between 2 mph and 6 mph (3 km/h and 10 km/h)

at a maximum distance of 40 m.

The system operates in addition to the Parking

sensors, Visiopark 1 or Visiopark 2 functions

(depending on version).

For more information about the Parking

sensors, Visiopark 1 or Visiopark 2 functions,

refer to the corresponding sections.

► Select the relevant view in the view from

above the vehicle.

The selected area turns yellow and the side view

appears in the middle of the screen.

This view is not recommended for carrying out a

complete manoeuvre.

This view is available automatically or by

selection in the left-hand side menu.

Panoramic view

Rear traﬃc alert

The driver must monitor their

surroundings before and during the

whole manoeuvre. Drive slowly and carefully

in reverse gear, in the event of reduced or no

visibility.

For more information, refer to the

General recommendations on the use

of driving and manoeuvring aids.

The rear or front panoramic view allows you to

leave a parking space by anticipating the arrival

of vehicles, pedestrians or cyclists.

148

Download User Manual App

Driving -> Visiopark 2 for Your Peugeot 308 4 Door 2021-2025

Related Topics

Driving

Popular Owner Manuals

Latest Owner Manuals