2019-2026 Renault Captur SUV Driving -> Electronic parking brake User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Electronic parking brake for Your Renault Captur SUV Second Generation (2019-2026)

ELECTRONIC PARKING BRAKE (1/4)  
1
In all other instances, for example the  
engine has stalled or is in standby  
due to the Stop and Start 2.12,  
the assisted parking brake is not ap-  
plied automatically. Manual mode must  
be used. For certain country-specific  
model versions, the assisted brake ap-  
plication function is not activated. Refer  
to the information on “Manual opera-  
tion”.  
3
4
To confirm that the electronic parking  
brake is applied, the message “Parking  
2
Brake ON” is displayed, the  
}
warning light appears on the instrument  
panel and the 3 warning light appears  
on the 4 switch.  
or  
Assisted operation  
After the engine is switched off, indi-  
cator light 3 goes out several minutes  
after the assisted parking brake has  
– for vehicles fitted with an automatic  
gearbox, when position P is en-  
gaged.  
Applying the electronic parking  
brake  
been applied and indicator light  
goes out when the vehicle is locked.  
}
With the vehicle stationary, the elec-  
tronic parking brake can be used to im-  
mobilise the vehicle:  
by pressing the engine start/stop  
button 1 or by turning the ignition  
key to the 2 “ON” position (2);  
or  
when the driver’s seat belt is un-  
fastened;  
The electronic parking brake can be used to immobilise the vehicle.  
Before leaving the vehicle, check that the electronic parking brake is fully  
applied.  
or  
Warning light 3 on switch 4 and warning light  
}
on the instrument  
when the driver’s door is opened;  
panel illuminate to show that the parking brake is applied but switch off when the  
doors are locked. Depending on the vehicle, a sticker is located on the upper sec-  
tion of the windscreen to remind you of this.  
2.25  
ELECTRONIC PARKING BRAKE (2/4)  
Assisted operation  
(continued)  
Note: in some situations (electronic  
parking brake failure, manual release of  
the parking brake, etc.), a beep sounds  
and the message “WARNING: Apply  
1
Parking Brake” appears on the instru-  
ment panel to warn you that the elec-  
tronic parking brake has been released.  
3
4
– with the engine running: when the  
driver’s door is opened;  
2
– with the engine switched off (e.g.  
when the engine stalls): when a front  
door is opened.  
Manually applying the electronic  
parking brake  
Pull switch 4. Warning light 3 and warn-  
In this case, pull and release switch 4 to  
apply the assisted parking brake.  
The electronic parking  
brake can be used to im-  
mobilise the vehicle. Before  
leaving the vehicle, check  
that the electronic parking brake is  
fully applied.  
Assisted release of the parking  
brake  
ing light  
light up.  
}
on the instrument panel  
The brake will be released as soon as  
the vehicle starts and accelerates.  
Manually releasing the electronic  
parking brake  
Warning light 3 on switch 4 and  
Press the 1 switch without pressing the  
pedals or turn the key 2 to the “ON”  
position 2 to switch on the vehicle igni-  
tion. Press the brake pedal then press  
switch 4: indicator light 3 on the switch  
warning light  
}
on the instru-  
Manual operation  
You can apply the electronic parking  
brake manually.  
ment panel illuminate to show  
that the parking brake is applied  
but switch off when the doors are  
locked.  
Depending on the vehicle, a sticker  
is located on the upper section of  
the windscreen to remind you of  
this.  
and indicator light  
the instrument panel go out.  
}
displayed on  
2.26  
ELECTRONIC PARKING BRAKE (3/4)  
– manually release the electronic park-  
ing brake (please see the informa-  
tion on “Manually releasing the elec-  
tronic parking brake” on the previous  
page);  
1
– depending on the vehicle, the elec-  
tronic parking brake is applied auto-  
matically. You will have to release it  
manually.  
3
4
2
To park the vehicle without applying the  
electronic parking brake (if there is a  
risk of freezing, for example):  
Brief stop  
To apply the electronic parking brake  
manually (when stopping at a red light,  
or stopping when the engine is running,  
etc.): pull and release the switch 4. The  
brake is released as soon as the vehi-  
cle is started up again.  
– engage any gear or the P position:  
the drive wheels will be mechanically  
locked by the driveshaft;  
– switch off the engine by pressing the  
engine start/stop button 1 or by turn-  
ing the ignition key 2;  
Special cases  
– release the driver’s seat belt;  
– open the driver’s door;  
To park on a slope or while towing a  
trailer, for example, pull switch 4 for  
a few seconds to gain the maximum  
braking.  
2.27  
ELECTRONIC PARKING BRAKE (4/4)  
Versions with an automatic  
gearbox  
Operating faults  
– If there is a fault, the © warning  
light illuminates on the instrument  
panel accompanied by the “Check  
Parking Brake” message and, in  
For safety reasons, automatic release  
is deactivated when the driver’s door  
is open or not shut properly and the  
engine is running (in order to prevent  
the vehicle from moving without the  
driver). The “Release Parking Brake  
Manually” message appears on the  
instrument panel when the driver de-  
presses the accelerator.  
some cases, the  
light.  
Contact your approved Dealer  
straight away.  
}
warning  
– If there is an assisted parking brake  
fault, the warning light ®  
comes on, along with the message  
“WARNING: Braking System”, a  
beep and, in some cases, the warn-  
If the “WARNING: Electric  
System” or “Check battery”  
or “WARNING: Braking  
System” message appears,  
you must immobilise the vehicle by  
selecting first gear (on a manual  
gearbox), engaging P position (au-  
tomatic gearbox) or by pulling the  
switch 4 for approximately 10 sec-  
onds.  
ing light  
}
.
This means that you must stop as  
soon as traffic conditions allow.  
Never leave your vehicle  
without re-engaging P po-  
sition and switching off the  
If no lights or sounds are ap-  
parent, this indicates a fault  
in the instrument panel. This  
If the conditions and the slope re-  
quire it, chock the wheels of the ve-  
hicle.  
engine. This is because  
indicates that it is essential  
Risk of loss of immobilisation of  
the vehicle.  
when the vehicle is stationary with  
the engine running and a gear en-  
gaged, the vehicle may begin to  
move if you accelerate.  
to stop immediately (as soon as traf-  
fic conditions allow). Ensure that the  
vehicle is correctly immobilised and  
contact an approved Dealer.  
Contact an authorised dealer.  
There is a risk of accidents.  
2.28  

Related Topics

Popular Owner Manuals