2023-2026 Renault Scenic 4 Door Driving -> Parking brake User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Parking brake for Your Renault Scenic 4 Door Fifth Generation (2023-2026)

PARKING BRAKE  
The electronic parking  
brake can be used to  
immobilise the vehicle.  
Electronic parking brake  
Assisted operation  
Before leaving the vehi-  
cle, check that the electronic  
parking brake is fully applied.  
Warning light 2 on switch 3 and  
3
warning light  
on the in-  
strument panel illuminate to  
show that the parking brake is  
applied but switch off when the  
doors are locked. Depending on  
the vehicle, a sticker is located  
on the upper section of the  
windscreen to remind you of  
this.  
or  
when position P is engaged.  
Applying the electronic parking  
brake  
With the vehicle stationary, the  
electronic parking brake can be  
used to immobilise the vehicle:  
In all other instances, the electronic  
parking brake is not applied auto-  
matically. Manual mode must be  
used.  
For certain country-specific model  
versions, the assisted brake applica-  
tion function is not activated. See  
the information on "Manual opera-  
tion".  
by pressing the engine start/stop  
button 1 ;  
or  
when the driver's seat belt is un-  
fastened;  
To confirm that the electronic park-  
or  
ing brake is applied, the  
ing light on the instrument panel and  
warn-  
when the driver's door is opened;  
D r i v i n g - 1 7 9  
PARKING BRAKE  
warning light 2 on the switch 3 light  
Press the switch 1 without pressing  
the pedals to switch the ignition on.  
Press the brake pedal then press the  
switch 3 : the warning light 2 on the  
up.  
The electronic parking  
brake can be used to  
immobilise the vehicle.  
After the engine is switched off, the  
indicator light 2 goes out a few min-  
utes after the electronic parking  
brake has been applied and the  
Before leaving the vehi-  
switch and the warning light  
warning light disappear from the in-  
strument panel.  
cle, check that the electronic  
parking brake is fully applied.  
Warning light 2 on switch 3 and  
3
warning light goes out when  
the vehicle is locked.  
Brief stop  
Note: in some situations (electronic  
parking brake failure, manual re-  
lease of the parking brake, etc.), to  
indicate that the electronic parking  
brake is released a beep sounds and  
the "WARNING: Apply Parking  
Brake" message appears on the in-  
strument panel:  
warning light  
on the in-  
To apply the electronic parking  
brake manually (when stopping at a  
red light, stopping when the engine  
is running, etc.): pull and release the  
switch 3 . The brake is released as  
soon as the vehicle is started up  
again.  
strument panel illuminate to  
show that the parking brake is  
applied but switch off when the  
doors are locked. Depending on  
the vehicle, a sticker is located  
on the upper section of the  
windscreen to remind you of  
this.  
with the engine on: when the  
driver’s door is opened;  
Special cases  
with the engine off: when a front  
door is opened.  
In this case, pull and release the  
switch 3 to apply the electronic  
parking brake.  
Parking on a slope  
To park on a slope or while towing a  
trailer, for example, pull switch 3 for  
a few seconds to enable maximum  
braking.  
Manual operation  
You can apply the electronic parking  
brake manually.  
Assisted release of the parking  
brake  
Parking with the electronic parking  
brake released  
Manually applying the electronic  
parking brake  
The parking brake is released:  
Pull the switch 3 . Warning light 2  
once the vehicle starts to acceler-  
Before deactivating  
the parking brake,  
make sure the vehicle  
is stable.  
and warning light  
nated on the instrument panel.  
Manually releasing the electronic  
parking brake  
are illumi-  
ate;  
or  
when shifting from position P.  
1 8 0 - D r i v i n g  
PARKING BRAKE  
To park with the electronic parking  
brake released, the parking brake  
must be deactivated. To do this:  
engage any gear or the P position:  
the drive wheels will be mechanical-  
ly locked by the driveshaft;  
stop the engine by pressing the  
engine Start/Stop button 1 ;  
unfasten the driver's seat belt;  
open the driver's door;  
manually release the electronic  
parking brake (please see the para-  
graph on "Manually releasing the  
electronic parking brake"). Make  
sure the vehicle is stable;  
some cases, the warning light  
Contact your approved Dealer  
straight away.  
In the event of an electronic park-  
ing brake fault, the warning light  
.
Never leave your vehi-  
cle without moving the  
selector lever to posi-  
tion P, applying the  
handbrake and switching off  
the engine. This is because  
when the vehicle is stationary  
with the engine running and a  
gear engaged, the vehicle may  
begin to move if you accelerate.  
There is a risk of accidents.  
3
lights up along with the  
"WARNING: Braking System" mes-  
sage, a beep and, in some cases, the  
warning light  
.
This means that you must stop as  
soon as traffic conditions allow.  
close the driver's door. If neces-  
sary, lock your vehicle.  
If the "Electrical fault",  
"Check battery" or  
"WARNING: Braking  
If no lights or sounds  
are apparent, this indi-  
cates a fault in the in-  
For safety reasons, automatic re-  
lease is deactivated when the  
driver’s door is open or not shut  
properly and the engine is running  
(in order to prevent the vehicle from  
moving without the driver). The "Re-  
lease Parking Brake" message ap-  
pears on the instrument panel when  
the driver presses the accelerator  
pedal.  
System" message ap-  
strument panel. This in-  
pears, you must immobilise the  
vehicle by engaging position P  
or by pulling the switch 3 for ap-  
proximately 10 seconds.  
If the conditions and the slope  
require it, chock the wheels of  
the vehicle.  
dicates that it is essential to  
stop immediately (as soon as  
traffic conditions allow). Ensure  
that the vehicle is correctly im-  
mobilised and contact an ap-  
proved Dealer.  
Risk of loss of immobilisation of  
the vehicle.  
Call an approved Dealer.  
Operating faults  
"Autohold" function  
Vehicle stopped (e.g. at a red light,  
an intersection, a traffic jam, etc.),  
the function ensures braking force  
In the event of a fault, the warning  
light  
lights up on the instru-  
ment panel along with the "Check  
Parking Brake" message and, in  
D r i v i n g - 1 8 1  
PARKING BRAKE  
even when the driver releases the  
brake pedal.  
The braking force is released as  
soon as the driver accelerates suffi-  
ciently with a gear engaged.  
The warning light on the switch 1 dis-  
appears to confirm that the function  
is deactivated.  
If the braking force is maintained,  
the parking brake is applied auto-  
matically when:  
the driver opens the door;  
or  
the driver unfastens their seat  
belt;  
The electronic parking  
brake can be used to  
immobilise the vehicle.  
Before leaving the vehi-  
cle, check that the electronic  
parking brake is fully applied.  
When the parking brake is ap-  
plied, this is confirmed by the il-  
lumination of the warning light  
on the switch 2 and the warning  
3
Activation  
or  
the vehicle is immobilised for more  
light  
displayed on the in-  
than approximately three minutes.  
strument panel until the doors  
have been locked. Depending  
on the vehicle, a sticker is locat-  
ed on the upper section of the  
windscreen to remind you of  
this.  
Upon each start-up, the  
function continues the  
mode set at the time the  
engine was last switched off.  
Conditions for maintaining the brak-  
ing force  
Press the switch 1 .  
The warning light on the switch 1  
comes on to confirm that the func-  
tion is activated.  
The following conditions must be  
met:  
the driver's door is closed;  
and  
Deactivation  
the driver's seat belt is fastened;  
and  
the electronic parking brake is re-  
leased;  
Press the switch 1 . If your vehicle is  
maintained by braking force you can  
also press the brake pedal.  
1 8 2 - D r i v i n g  
PARKING BRAKE  
and  
the vehicle is not stationary on a  
very steep slope.  
The maintained braking force is con-  
firmed by the warning light  
the instrument panel.  
Conditions for interrupting the brak-  
ing force  
on  
3
The following conditions must be  
met:  
the driver accelerates sufficiently  
with a gear engaged;  
or  
the driver disables the function.  
The warning light  
disappears  
from the instrument panel.  
D r i v i n g - 1 8 3  

Related Topics

Popular Owner Manuals