Get Driving -> Cruise control Guide for Renault Symbioz 4 Door First Generation (2024-2026)

CRUISE CONTROL

1. Switch for selecting/deselecting

the driving aids, depending on the

vehicle:

The cruise control function controls

the engine and braking system to

help you to maintain a driving speed

that you have chosen, known as the

cruising speed.

This cruising speed can be set at any

speed above 19 mph (30 km/h).

This function is an ad-

ditional driving aid.

It can under no circum-

– Active driver assist;

– Adaptive Cruise Control;

– cruise control;

– speed limiter;

stances replace the

driver's responsibility to respect

speed limits or to be vigilant.

The driver must always be in

control of the vehicle.

Cruise control must not be used

in heavy traffic, on winding or

slippery roads (black ice, aqua-

planing, gravel) and during bad

weather (fog, rain, side winds

etc.).

3

– OFF.

2. Puts the function on standby and

stores the limited speed (0).

Depending on the vehicle,

you can link the cruise

control function to the

"Road sign detection" function

ꢀ 217.

3. Recall the stored cruising speed

(RES).

4. Activates and decreases the

cruising speed or stores the current

speed (SET/-).

There is a risk of accidents.

5. Switch to activate and increase

cruising speed or to recall the mem-

orised cruising speed (SET/+).

Controls

6. Pop-up button (depending on the

vehicle): adapts the speed setpoint

to detected speed limits

ꢀ 217

When the "OFF" mode is selected

before the ignition is switched off,

the "Speed limiter" function will be

activated by default the next time

the engine is started.

2 3 0 - D r i v i n g

CRUISE CONTROL

Switching on

Press switch 1 as many times as nec-

essary to select the cruise control 7 .

The 8 warning light appears in grey.

The "Cruise control ready: SET to ac-

tivate" message appears on the in-

strument panel accompanied by

dashes to indicate that the cruise

control function is activated and

waiting to store a cruising speed.

Please note that you

must keep your feet

close to the pedals in

order to react in an

emergency.

3

Adjusting the cruising speed

The cruising speed may be changed

by repeatedly pressing the:

Activating cruise control

While the vehicle is moving a steady

speed above approximately 19 mph

(30 km/h), press switch 5 (SET/+) or

switch 4 (SET/-): the function is acti-

vated and the current speed is taken

into account. The cruising speed re-

places the dashes.

The cruising speed replaces the

dashes. Cruise control is confirmed

when the memorised speed and

warning light appear in green 8 .

– switch 4 (SET/-) to reduce the

speed;

– switch 5 (SET/+) to increase the

speed.

Note: press and hold one of the

switches to modify speed by succes-

sive increments.

Exceeding the cruising speed

The cruising speed may be exceed-

ed at any time by depressing the ac-

celerator pedal.

While it is being exceeded, the cruis-

ing speed flashes in red on the in-

strument panel. Then, release the

accelerator pedal: after a few sec-

onds, the vehicle will automatically

return to its set cruising speed.

If you try to activate the function be-

low 19 mph (30 km/h), the "Speed in-

valid" message will be displayed and

the function will remain deactivated.

Driving

Once a cruising speed is registered

and the cruise control function is ac-

tive, you may lift your foot off the ac-

celerator pedal.

Cruising speed cannot be main-

tained

D r i v i n g - 2 3 1

CRUISE CONTROL

In the case of a steep descent, the

system may not maintain the cruis-

ing speed: the stored speed flashes

in red on the instrument panel and a

beep sounds at regular intervals to

inform you.

– the switch 2 (0);

speed and, depending on the vehi-

– the brake pedal;

cle, the warning light 8 appears.

– move to the neutral position.

Note: if the speed previously stored

is much higher than the current

speed, the vehicle will accelerate

more rapidly to reach this threshold.

The cruising speed is stored and dis-

played in grey on the instrument

panel.

3

Returning to the cruising speed

When the cruise control is on stand-

by, press switch 4 or 5 to reactivate

the cruise control function without

taking into account the stored

speed: it is the speed at which the

vehicle is moving that is taken into

account.

If a speed is stored, it can be re-

called, once you are sure that the

road conditions are suitable (traffic,

road surface, weather conditions,

etc.). Press the switch 3 (RES) if the

vehicle speed is above 19 mph (30

km/h).

If the cruise control is

no longer available (af-

ter several attempts to

activate it), contact an

Approved Dealer.

Switching off the function

Putting the function on stand-

by

The cruise control function is inter-

rupted when you press the switch 1

to deselect the cruise control. In this

case, the speed is no longer stored.

When the speed is stored, cruise

control activation is confirmed by

the display in green of the cruising

The function is set to standby if you:

2 3 2 - D r i v i n g

CRUISE CONTROL

To exit the driving assis-

Putting the cruise con-

trol on standby or

tance, press switch 1 as

many times as necessary

until you reach OFF. The "Driving

Assistance deactivated" mes-

sage appears on the instrument

panel.

switching it off does

not cause a rapid re-

duction in speed: you must

brake by pressing the brake

pedal.

3

In this case, the next time the

engine is started, the "Speed

limiter" function will be activat-

ed and waiting for a speed limit

to be stored.

The 8 warning light disappears from

the instrument panel to confirm that

the function has stopped.

D r i v i n g - 2 3 3

Driving -> Cruise control for Your Renault Symbioz 4 Door First Generation (2024-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals