Get Getting to know your vehicle -> Wiper Guide for Renault Symbioz 4 Door First Generation (2024-2026)

WIPER

For example, fast wiping speed will

slow to normal wiping speed.

As soon as the vehicle moves off,

wiping will return to the speed origi-

nally selected.

Windscreen washer, wiper

Vehicle fitted with intermittent

windscreen wipers

2

Any action on the stalk 1 overrides

and cancels the automatic function.

Vehicle fitted with front wind-

screen wiper rain sensor

A. a single sweep of the wipers

A short push will trigger one sweep

of the wipers.

B. stopping

C. intermittent wiping

The wipers will pause for several

seconds between sweeps. It is possi-

ble to change the interval between

sweeps by turning the ring 2 .

D. slow continuous wiping

E. fast continuous wiping

Special feature

When driving the vehicle, the wiping

speed slows down whenever the ve-

hicle stops.

1 3 2 - G e t t i n g t o k n o w y o u r v e h i c l e

WIPER

The higher the sensitivity, the quick-

er the wipers will react and the

faster the wipe.

When activating automatic wiping

or when increasing sensitivity, one

sweep of the blades is performed.

The rain sensor operation may be in-

terrupted in the event of:

– damaged windscreen wipers: a

film of water or traces left by a blade

in the sensor's detection zone may

increase the response time of the

automatic wiper, or increase the

wiping frequency;

– a windscreen with any chip or

crack near the sensor, or a wind-

screen covered in dust, dirt, insects,

ice, the use of washing wax and wa-

ter-repellent chemicals. The wind-

screen wiper will be less sensitive or

may even not react at all.

D. slow continuous wiping

E. fast continuous wiping

Special feature

When driving the vehicle, the wiping

speed slows down whenever the ve-

hicle stops.

For example, fast wiping speed will

slow to normal wiping speed.

As soon as the vehicle moves off,

wiping will return to the speed origi-

nally selected.

Any action on the stalk 1 overrides

and cancels the automatic function.

Precautions

2

Note:

– the rain sensor is only intended as

a driving aid. In the event of reduced

visibility, the driver should manually

activate the wipers. In foggy weath-

er or during snowfalls, wiping is not

automatically triggered and re-

mains under the driver's control;

– in the event of temperatures be-

low zero, automatic wiping is not ac-

tivated when the vehicle is started. It

is automatically activated as soon

as the vehicle exceeds a certain

speed (approximately 5 mph (8 km/

h));

The rain sensor is located on the

windscreen, in front of the interior

rear view mirror.

A. a single sweep of the wipers

A short push will trigger one sweep

of the wipers.

– do not activate automatic wiping

in dry weather;

B. stopping

– fully de-ice the windscreen before

activating automatic wiping;

– when washing the vehicle under a

roller type car wash, set the stalk 1 to

position B to deactivate automatic

wiping.

C. automatic wiper function

When this position is selected, the

system detects water on the wind-

screen and triggers the wipers at a

suitable wiping speed.

It is possible to change the trigger-

ing threshold and the interval be-

tween sweeps by turning the ring 2 :

Operating faults

In the event of a malfunction of the

automatic wiping, the wiper is set to

intermittent wiping.

– In the event of ice, check whether

the blades are stuck to the wind-

screen before operating the wiping

–

F : minimum sensitivity;

G : maximum sensitivity.

Call an approved dealer.

G e t t i n g t o k n o w y o u r v e h i c l e - 1 3 3

WIPER

mechanism. If you activate the

wipers while the blades are stuck

down with ice, you may risk damag-

ing both the blade and the wiper mo-

tor.

– Do not activate the wipers on a dry

screen. This will lead to premature

wear or damage to the blades.

age to the bonnet or the wipers

when they are switched on.

In the event of obstacles

on the windscreen (dirt,

snow, ice etc.), clean the

windscreen (including the cen-

tral area located behind the in-

terior rear view mirror) before

starting the wipers (risk of mo-

tor overheating).

If an object is preventing a

blade from moving, it may stop

functioning.

Remove the obstacle and reac-

tivate the wiper using the wiper

stalk.

2

Specific front wiper position (ser-

vice position)

This position enables the blades to

be lifted to remove them from the

windscreen.

It may be useful to:

– clean the blades;

– release the blades from the wind-

screen in winter;

– replace the blades ꢀ 360.

With the ignition on or engine start-

ed, lift the stalk 1 twice to position A

(single sweep).

The blades stop slightly away from

the bonnet.

To return the blades to the lowered

position, with the ignition on, ensure

that the wipers have folded down

onto the windscreen, then move the

stalk 1 to position A (single sweep).

Before any action in-

volving the windscreen

(washing the vehicle,

de-icing or cleaning the

windscreen, etc.) return the

stalk 1 to position B (park).

Risk of injury and/or damage.

Before switching on the ignition,

place the wipers on the windscreen.

Otherwise, there may a risk of dam-

1 3 4 - G e t t i n g t o k n o w y o u r v e h i c l e

WIPER

Windscreen washer

When working in the

engine compartment,

ensure that the wind-

screen wiper stalk is in

Efficiency of a wiper

blade

Check the condition of

the wiper blades. How long they

last depends on you:

2

position B (stop).

Risk of injury.

– it must remain clean: clean

the blade and the screen regu-

larly with soapy water;

– do not use it when the screen

is dry;

– free it from the screen when it

has not been used for a long

time.

In all cases, replace it as soon as

it begins to lose efficiency: ap-

proximately once a year ꢀ 360.

Precaution for using the wipers

With the ignition on, pull the stalk 1

then release.

A longer pull will trigger, in addition

to the windscreen washer, two

sweeps of the wipers followed, a few

seconds later, by a third.

On vehicles fitted with a multimedia

screen, you can choose to activate

or deactivate the third sweep of the

blades ꢀ 112.

– In freezing or snowy condi-

tions, clear the screen before

starting the wipers (risk of mo-

tor overheating);

– ensure that no objects are ob-

structing the travel of the blade.

Note: in temperatures below zero,

the washer liquid may freeze on the

windscreen, reducing visibility. Heat

the windscreen using the demister

control before cleaning.

G e t t i n g t o k n o w y o u r v e h i c l e - 1 3 5

WIPER

When washing using a roller type car

wash, return the ring 3 on the stalk 1

to the stop position to deactivate

automatic wiping.

Rear windscreen wash, wiper

Rear windscreen wiper

Efficiency of a wiper

blade

Check the condition of

the wiper blades. How long they

last depends on you:

2

Follow usage recommendations.

– it must remain clean: clean

the blade and the screen regu-

larly with soapy water;

– do not use it when the screen

is dry;

Do not use the wiper arm

to open or close the tail-

gate.

– free it from the screen when it

has not been used for a long

time.

Before taking any ac-

tion involving the rear

screen (washing the

In all cases, replace it as soon as

it begins to lose efficiency: ap-

proximately once a year ꢀ 360.

Precaution for using the wipers

vehicle, de-icing, clean-

ing, etc.) return the stalk 1 to the

off position.

Risk of injury and/or damage.

With the ignition on, rotate the

ring 3 on the stalk 1 until the symbol

is aligned with the mark 2 :

– In freezing or snowy condi-

tions, clear the screen before

starting the wipers (risk of mo-

tor overheating);

–

off;

intermittent wiping.

– ensure that no objects are ob-

structing the travel of the blade.

The wipers will pause for several

seconds between sweeps. The

wiping frequency varies accord-

ing to the vehicle speed;

Activation/deactivation of the

rear screen wiper

–

slow continuous wiping.

To stop the operation, rotate the ring

3 again.

Note:

Engaging reverse gear triggers in-

termittent wiping (if the front wipers

1 3 6 - G e t t i n g t o k n o w y o u r v e h i c l e

WIPER

are in operation). If your vehicle is

equipped with a vehicle settings

customisation menu, you can opt to

activate or deactivate this function

ꢀ 112.

For vehicles not fitted with a settings

customisation menu, you can have

this function deactivated by an au-

thorised dealer.

Rear screen wash/wipe

With the ignition on, push and

hold the stalk 1 then release it.

Holding the stalk for longer will trig-

ger (in addition to the windscreen

washer) two sweeps of the wipers

followed, a few seconds later, by a

third (drip wiping function).

2

In the event of obstacles present on

the rear window (dirt, snow, etc.), the

wiper will try to sweep away all the

obstacles. If an obstacle prevents

the blade from moving, it can be

stopped. Remove the obstacle, wait

for around 30 seconds and reacti-

vate the wiper using the wiper stalk.

When the stalk is released, it returns

to the rear wipe position.

Precautions

– In the event of ice, check that the

blades are not stuck to the wind-

screen before operating the wipers.

If you activate the wiper while the

blade is blocked by ice, you risk dam-

aging both the blade and the wiping

motor.

– Do not operate the wipers on a dry

screen. This will lead to the prema-

ture wear or damage to the blades.

G e t t i n g t o k n o w y o u r v e h i c l e - 1 3 7

Getting to know your vehicle -> Wiper for Your Renault Symbioz 4 Door First Generation (2024-2026)

Related Topics

Popular Owner Manuals

Latest Owner Manuals