Amarok 2011 ➤, Amarok 2017 ➤
Electrical system - Edition 12.2020
4
Side turn signals
⇒ a4.1 nd installing turn signal repeater”, page 163
⇒ t4.2 urn signal repeater bulb”, page 164
4.1
Removing and installing turn signal re‐
peater
Note
♦ The illustrations show removal and installation of the left turn
signal repeater.
♦ Removal and installation of the right turn signal light are
analogous.
Caution
Risk of damage when turn signal repeater is being removed!
♦ It is only possible to remove turn signal repeater in one
direction, therefore great care must be taken during re‐
moval.
♦ Attempting to lever out the light on the spring clip side by
force runs the risk of damaging the turn signal repeater
or the vehicle paintwork.
♦ When seen from outside in installed condition, it is not
possible to tell on which side of the turn signal repeater
the bearing point is located and on which side the spring
clip is located.
♦ Locate spring clip by carefully pushing turn signal re‐
peater sideways.
Removing:
– Switch off ignition and all electrical consumers, and withdraw
ignition key.
Note
If the respective vehicle equipment allows for reaching the rear
of the turn signal repeater on the inside of the wing with the
hand, the turn signal repeater can also be pushed against the
spring clip and pushed out accordingly from behind.
– Mask off the painted area on both sides of the turn signal.
– Carefully press the turn signal light in the direction of the
spring clip -arrow- and, starting with the fixed anchor point,
pull it out of the body.
4. Side turn signals
163
English 
