Advertisement

Advertisement

Quick help -> Battery for Your Citroen Relay Van 2014-2024

AdBlue®  
Park the vehicle  
top-up  
-
Obtain a bottle of AdBlue®. After first  
refilling / topping-up the  
AdBlue®  
-
Before topping-up, ensure that the  
vehicle is parked on a flat and level  
surface.  
checking the use-by date, read carefully  
the instructions on use on the label  
before pouring the contents of the bottle  
into your vehicle's AdBlue® tank.  
Precautions to take  
Important: if your vehicle's  
AdBlue® tank is completely empty -  
which is confirmed by the alert messages  
and the impossibility of starting the engine,  
you must add at least 3.8 litres  
Use only AdBlue® that meets  
(so two 1.89 litre bottles).  
the ISO 22241 standard.  
Please check the use-by date.  
Read the instructions on the label.  
Ensure that you have a suitable filler pipe,  
which may or may not be supplied with the  
container.  
Open the filler  
-
Open the fuel filler flap.  
-
After emptying the bottle, wipe away any  
spillage around the tank filler using a  
damp cloth.  
-
Turn the blue cap a 6th of a turn anti-  
clockwise.  
-
Remove the blue cap downwards.  
To facilitate filling, an adaptor is  
available from CITROËN dealers.  
If any fluid is split or splashed, wash  
immediately with cold water or wipe  
with a damp cloth.  
If the fluid has crystallised, clean it off using  
a sponge and hot water.  
AdBlue®  
refit the filler cap  
recommendations on storage  
-
Refit the blue cap to the tank and turn it  
a 6th of a turn clockwise, to its stop.  
Never store containers or bottles of  
AdBlue® in your vehicle.  
The SCR system includes an AdBlue®  
tank heater that ensures operation of  
the vehicle in normal conditions.  
-
Close the filler flap.  
In exceptional situations, such as when the  
vehicle is kept at temperatures below -15°C  
(5°F) for a long period, there may be an  
emission fault alert related to freezing of the  
AdBlue® additive.  
Freezing of the AdBlue®  
AdBlue® freezes at about -11°C  
(12.2° F) and deteriorates above 25°C  
(77°F).  
restart the engine  
-
-
Switch the ignition on, without starting.  
Wait 10 seconds before starting the  
engine.  
It is recommended that containers and  
bottles be stored in a cool area and  
protected from direct sunlight.  
Park the vehicle in an area at a more  
moderate temperature for a few hours until  
the AdBlue® becomes a fluid again.  
Never dispose of AdBlue® fluid bottles  
in the household waste.  
Under these conditions, the fluid can be kept  
for at least a year.  
The emissions warning lamp does not go off  
immediately, but does so after a few miles  
of driving.  
Additive that has been frozen can be used  
once it has thawed out in ambient air.  
Place them in a special container provided  
this purpose or take them to your dealer.  
Keep AdBlue® out of the reach of  
children, in its original container.  
Never transfer AdBlue® to another container:  
it would loose its purity.  
Never dilute the fluid with water.  
Never pour the fluid into the Diesel fuel tank.  
7
Discharged battery  
BAttErY  
A. Positive metal point on your vehicle  
B. Slave battery  
Starting from another  
battery  
charging the battery using a  
charger  
-
-
-
Connect the red cable to the metal  
point A then to the positive (+) terminal  
of the slave battery B.  
-
Go to the battery located in the front  
c. Earth on your vehicle  
left floor.  
The positive metal point A is accessible by a  
flap, located on the side of the fusebox.  
-
-
Disconnect the battery.  
Connect one end of the green or black  
cable to the negative (-) terminal of the  
slave battery B.  
Follow the instructions for use given by  
the battery charger manufacturer.  
-
-
Reconnect starting with the negative (-)  
terminal.  
Connect the other end of the green or  
black cable to the earth point c on your  
vehicle.  
Check that the terminals and connectors  
are clean. If they are covered with  
sulphate (white or greenish deposit),  
disconnect them and clean them.  
Make connections only to the points  
indicated and illustrated above. Failure  
to observe this instruction introduces  
the risk of short-circuit!  
-
-
Operate the starter, let the engine run.  
Wait for the engine to return to idle, then  
disconnect the cables.