Get Quick help -> Changing a bulb Guide for Citroen Relay Van 2014-2024

Failed fuse

Fuses

A (amps)

Allocation

54

55

56

57

58

59

60

61

62

63

64

65

-

Not used

15

10

15

-

Heated seats

Rear passenger 12 V socket

Under seat additional heating

Heated rear screen, left-hand

Heated rear screen, right-hand

Not used

-

Not used

-

Not used

10

-

Rear passenger additional control

Not used

door pillar, right-hand side, fuses

30

Rear passenger additional heating fan

Unclip the cover

When you have finished, close the cover

carefully.

8

Failed fuse

Fuses

A (amps)

Allocation

1

2

3

4

40

50

30

40

ABS pump supply

Diesel pre-heat unit

Ignition switch - Starter motor

Fuel heater

Cabin ventilation with additional programmable heating

(battery +)

5

20/50

6

40/60

Cabin fan maximum speed (battery +)

Cabin fan minimum speed (battery +)

Cabin fan assembly (ignition switch +)

Rear 12 V socket (battery +)

Horn

7

40/50/60

8

40

15

-

9

10

11

14

15

16

17

18

19

20

21

22

23

Not used

Fuses in the engine compartment

15

-

Front 12 V socket (battery +)

Cigarette lighter (battery +)

Not used

Remove the nuts and tilt the box to access

the fuses.

refit the cover carefully after checking or

replacing fuses.

-

Not used

7.5

30

15

-

Engine management control unit (battery +)

Air conditioning compressor

Screenwash/headlamp wash pump

Fuel pump supply

Not used

30

ABS electrovalves

Auxiliary switch panel - Door mirror controls and folding

(ignition switch +)

24

30

7.5

15

Door mirror heating

Failed bulb or lamp

cHAnGInG A BuLB

types of bulb

When using a high pressure washer

on stubborn dirt, do not persist on

the headlamps, the lamps and their edges

to avoid damaging their lacquer finish and

seals.

Various types of bulb are used on your

vehicle.

To remove them:

type A Entirely glass bulb: pull gently

as it is fitted by pressure.

For removing and refitting the screws,

use the screwdriver stowed in the tool

box under the front passenger's seat.

type B Bayonet bulb: press on the bulb

Carry out the operations in reverse order to

then turn it anticlockwise.

refit each bulb.

type c cylindrical bulb: move aside the

contacts.

type d - E

Halogen bulb: release the

retaining spring from its

housing.

Always replace a failed bulb with

a new bulb of the same type and

specification.

8

Failed bulb or lamp

2 - dipped beam headlamps

type d, H7 - 55 W

Front lamps

Open and secure the bonnet with the stay.

On the left hand side, take care not to

dislodge the bonnet stay.

-

Remove the cover by pulling on the

rubber tongue.

To access the bulbs, reach behind the

headlamp unit.

-

Disconnect the electrical connector.

1 - Main beam headlamps

type d, H7 - 55 W

If necessary you can remove the headlamp:

Release the retaining spring by pressing

on the central clip.

-

Depending on the country of sale,

remove the very low temperature

protection padding by sliding it towards

the outside of the vehicle.

-

Remove the cover by pulling on the

rubber tongue.

-

Change the bulb taking care to align the

metal part with the grooves on the lamp.

-

Disconnect the electrical connector.

-

Disconnect the electrical connector by

removing its locking ring.

Release the retaining spring by pressing

on the central clip.

3 - direction indicators

type A, WY 21 W - 21 W

Remove the two headlamp fixing

screws.

-

Change the bulb taking care to align the

metal part with the groove on the lamp.

-

Remove the cover by pulling on the

rubber tongue.

Move the headlamp towards the centre

of the vehicle to extract it from its

sliders.

Turn the bulb holder a quarter turn

anticlockwise.

Change the bulb.

Failed bulb or lamp

4 - Sidelamps / daytime running lamps

type A, W21/5W - 21W and 5W

-

Remove the cover by pulling on the

rubber tongue.

Turn the bulb holder a quarter of a turn

anti-clockwise.

Change the bulb.

5 - Front foglamps

-

Remove the fixing clip and disconnect

the electrical connector.

type E, H11 - 55 W

-

Turn and disengage the bulb holder.

-

Turn the steering so that the wheel on the

side in question is turned fully inwards.

Change the bulb taking care to align the

metal part with the grooves on the lamp.

Remove the screw located in the wheel

arch.

Remove the protective cover.

Halogen bulbs must be changed after

the headlamp has been off for several

minutes (risk of serious burns). Do not touch

the bulb directly with your fingers, use a

lint-free cloth.

LEd daytime running lamps

These light-emitting diode (LED) lamps

serve as both daytime running lamps and

sidelamps.

When each operation has been completed,

check the operation of the lamps.

If your vehicle is fitted with LED daytime

running lamps, contact a CITROËN dealer.

8

Failed bulb or lamp

Front / rear

direction indicator side

repeaters

Side marker lamps

courtesy lamps

type A, W5W - 5W

type A, W 16 W F - 16 W

type c, 12 V 10 W - 10 W

-

If your vehicle is fitted with these lamps

(L4 body), remove the two fixing screws.

-

Move the mirror glass to access the

screws.

-

Press at the points indicated by the

arrows, then remove the courtesy lamp.

Pull the bulb holder to release it from

the lugs.

-

Remove the two fixing screws.

-

Open the protective flap.

-

Pull the bulb holder to release it from

Change the bulb moving aside the

two contacts.

Pull the bulb out and change it.

the lugs.

-

Pull the bulb out and change it.

-

Ensure that the new bulbs are secured

correctly between the two contacts.

-

Close the protective flap.

Fix the courtesy lamp in its housing and

ensure that it is secured correctly.

Quick help -> Changing a bulb for Your Citroen Relay Van 2014-2024

Related Topics

Quick help

Popular Owner Manuals

Latest Owner Manuals