Advertisement

Advertisement

Quick help -> Towbar with quickly detachable towball for Your Citroen Relay Van 2014-2024

Puncture  
If a pressure of at least 3 bar is not  
-
reached within 5 minutes, disconnect  
the compressor from the valve and the  
power socket, then move the vehicle  
forward by approximately 10 metres  
to distribute the sealant fluid inside  
the tyre.  
-
Then repeat the inflation operation:  
● if a pressure of at least 3 bar is not  
reached within 10 minutes, switch off  
your vehicle: the tyre has suffered  
too much damage and repair has not  
been possible. Contact a CITROËN  
dealer or a qualified workshop.  
checking and adjusting the  
pressure  
replacing the cartridge  
To replace the sealant cartridge, carry out  
the following operations:  
● if the tyre has been inflated to a  
pressure of 5 bar, set off again  
immediately.  
The compressor can only be used to check  
and adjust the pressure.  
-
disconnect the hose I,  
-
Disconnect the hose I and connect it to  
the tyre valve directly; the cartridge will  
then be connected to the compressor  
and the filling fluid will not be injected.  
-
turn the cartridge to be replaced  
anticlockwise and lift it,  
After driving for approximately 10 minutes,  
stop and check the pressure of the tyre  
again.  
-
insert the new cartridge and turn it  
clockwise,  
Adjust the pressure to the value given on the  
label on the driver's door pillar, and contact  
a CITROËN dealer or a qualified workshop  
as soon as possible.  
If it is necessary to deflate the tyre, connect  
the hose I to the tyre valve and press the  
yellow button, placed in the centre of the  
switch on the compressor.  
-
reconnect the hose I and connect the  
hose B in its location.  
The cartridge contains ethylene-glycol,  
a product which is harmful if swallowed  
and which causes irritation to the eyes.  
Keep out of reach of children.  
This puncture repair kit and  
replacement cartridges are available  
from CITROËN dealers.  
After use, do not discard the cartridge in the  
environment, take it to a CITROËN dealer or  
an appropriate waste disposal organisation.  
Being towed or towing  
General recommendations  
Observe the legislation in force in your  
country.  
Ensure that the weight of the towing vehicle  
is higher than that of the towed vehicle.  
The driver must remain at the wheel of the  
towed vehicle and must have a valid driving  
licence.  
When towing a vehicle with all four wheels  
on the ground, always use an approved  
towing arm; rope and straps are prohibited.  
The towing vehicle must move off gently.  
When towing a vehicle with the engine off,  
there is no longer any power assistance for  
braking or steering.  
tOWInG  
towing the vehicle  
towing another vehicle  
In the following cases, you must always call  
on a professional recovery service:  
The removable towing eye is located in the  
tool box under the front passenger seat.  
The fixed towing eye is located on the right  
below the bumper.  
-
vehicle broken down on a motorway or  
Unclip the cover using a flat tool.  
Attach the approved towing arm to the  
fixed eye.  
fast road,  
Screw the removable towing eye in fully.  
-
-
four-wheel drive vehicle,  
Attach the approved towing arm to to the  
removable towing eye.  
when it is not possible to put the  
gearbox into neutral, unlock the  
steering, or release the parking brake,  
Place the gear lever in neutral.  
-
-
towing with only two wheels on the  
ground,  
Failure to observe this requirement  
may result in damage to certain braking  
components and the lack of some braking  
assistance systems when the engine is  
re-started.  
where there is no approved towing arm  
available...  
8
transport solutions  
For information on the maximum  
trailer weight and the recommended  
nose weight, refer to the "Technical data -  
Weights" section.  
Before each use  
tOWBAr WItH QuIcKLY  
dEtAcHABLE tOWBALL  
Check that the towball is correctly  
locked and verify the following points:  
Presentation  
-
the green mark on the locking wheel  
is in line with the green mark on the  
towball,  
This towball can be fitted and removed  
quickly and easily without the use of tools.  
For information on safely towing a trailer,  
refer to the "Accessories - Towing a trailer"  
section.  
-
-
the locking wheel is in contact with the  
towball,  
the key lock is on and the key removed;  
the locking wheel can no longer be  
operated,  
-
the towball must no longer move at all in  
its carrier; try to shake it by hand.  
during use  
Never unlock the device when a trailer or  
load carrier is fitted to the towball.  
Never exceed the maximum authorised  
weight for the vehicle (the Gross Vehicle  
Weight - GVW), the trailer, or the sum of the  
two (the Gross Train Weight - GTW).  
1. Carrier  
A. Locked position; the locking wheel is in  
After use  
contact with towball (no gap).  
2. Connector socket.  
3. Safety eye.  
For journeys made without a trailer or load  
carrier, the towball must be removed and  
the blanking plug inserted in the carrier. This  
measure applies particularly if the towball  
could hinder visibility of the number plate or  
lighting.  
B. unlocked position; the locking wheel  
and towball are no longer in contact  
(gap of about 5 mm).  
4. Detachable towball.  
5. Locking / unlocking wheel.  
6. Key lock.  
7. Key reference label.  
Observe the legislation in force in the  
country in which you are driving.  
transport solutions  
Fitting the towball  
Insert the end of the towball 4 into the  
carrier 1 and push upwards; it locks in place  
automatically.  
Check that the mechanism has correctly  
locked in to place (position A).  
Below the rear bumper, remove the  
protective plug from the towball carrier.  
Close the lock 6 using the key.  
The locking wheel 5 turns a quarter of a turn  
anti-clockwise; take care to keep your hands  
clear.  
Always remove the. The key cannot be  
removed when the lock is open.  
Clip the cap onto the lock.  
8