Operation
WARNING
Adjusting the headrests
Headrest
If travelling with the headrests removed or
improperly adjusted, the risk of severe or
fatal injuries in the event of accidents and
sudden braking or manoeuvres increases.
Introduction
The possibilities for the adjustment and dis-
assembly of the headrests are described be-
low. Always make sure that the seats are cor-
●
Always travel with the headrest correctly
installed and adjusted.
rectly adjusted page 13 .
›››
●
To decrease the risk of cervical injuries in
the event of an accident, adjust the head-
rest correctly based on your height, always
making sure that its upper edge is at the
same height as the top of the head, but
never below eye level. Keep the back of
your head always as close to the headrest as
possible and centred.
All seats are equipped with a headrest. The
central rear headrest is only intended for the
central seat of the rear bench. Therefore, do
not install it on any other seat.
Fig. 103 Front seat: headrest adjustment.
Correct adjustment of headrest
Adjust the headrest so that its upper edge is
at the same level as the top of your head and
under no circumstances below eye level.
Keep the back of your head always as close
to the headrest as possible.
●
Never adjust the headrest while the vehi-
cle is in motion.
●
Under no circumstances should the rear
passengers travel while the headrests are in
the non-use position.
Adjusting the headrest for short people
CAUTION
Lower the headrest completely, even if your
head is below its upper edge. In the lowest
position, there may be a small distance be-
tween the headrest and the backrest.
When assembling and disassembling the
headrests, do not let them meet the top
lining of the vehicle, the back rest of the
front seat or other parts of the vehicles. If
not, this could damage the vehicle.
Fig. 104 Rear headrest: headrest adjust-
ment.
Adjusting the height of the headrests
Adjusting the headrest for tall people
●
Grab the sides of the headrests with both
Push the headrest up as far as it will go.
hands and push upwards to the desired posi-
tion. To lower it, repeat the same action,
1
pressing the
Fig. 103
Fig. 104 but-
›››
›››
ton on the side.
130
English 
