Get Operation -> Seats and headrests Guide for Cupra Formentor SUV First Generation (2020-2024)

Operation

WARNING

Sun protection

Seats and headrests

Adjusting seats

Folded sun blinds can reduce visibility.

sun blind

●

Always store sun blinds and visors in their

housing when not in use.

Manual adjustment of the front

seats

Note

The light above the sun visor automatically

switches off after a few minutes in certain

conditions. This prevents the battery from

discharging.

Fig. 100 Sun visor

Options for adjusting driver and front pas-

senger sun visors

●

Lower the sun visor towards the wind-

screen.

Fig. 101 Front seats: manual seat settings.

●

The sun visor can be pulled out of its

mounting and turned towards the door

Forwards/backwards: pull the lever and

move the seat. The seat must engage

when the lever is released!

Fig. 100

›››

●

Swing the sun visor towards the door, lon-

gitudinally backwards.

Raise/lower: pull the lever up or push

down (several times if necessary) from its

home position.

There is a vanity mirror on the sun visor, with

a cover. When the cover is opened

comes on.

a light

Tilting the backrest: turn the hand wheel.

Lumbar support: move the lever until the

required position is achieved.

The lamp goes out when the vanity mirror

cover is closed or the sun visor is pushed

back up.

128

Seats and headrests

Electric driver's seat adjustment

WARNING

●

Incorrect seat adjustment may lead to acci-

dents and severe injuries.

If the electric front seats are used negli-

gently or without paying due attention, it

can cause serious injury.

●

Only adjust the seats when the vehicle is

●

stationary, as the seats could move unex-

pectedly while the vehicle is in motion and

you could lose control of the vehicle. Fur-

thermore, an incorrect position is adopted

when adjusting the seat.

The front seats can also be electrically

adjusted when the ignition is switched off.

Never leave a child or any other person who

may need help in the vehicle.

●

In the event of an emergency, electrical

●

Adjust the height, position and inclina-

adjustment can be stopped by pressing any

control.

tion of the front seats only when their

movement area is empty.

●

Make sure there are no objects in that

CAUTION

area.

To avoid damaging the electrical compo-

nents of the front seats, please refrain from

kneeling on the seat or applying sharp

pressure at a single point to the seat cush-

ion and backrest.

●

Make sure that the movement and lock-

Fig. 102 Driver's seat: electric seat set-

tings.

ing areas of the seats are clean.

WARNING

Adjust the lumbar support: press the

button according to the desired position.

Incorrectly using upholstery and seat cov-

ers might cause an accidental activation of

the electrical seat adjustment system and

make it move unexpectedly while driving.

This might cause loss of control of the vehi-

cle and thus accidents or injuries. More-

over, the electrical components of the

front seats might be damaged.

Note

Seat forwards/backwards: press the but-

ton forwards/backwards.

●

It may not be possible to electrically ad-

just the seat if the vehicle battery is very

low.

Seat up/down: Press the rear part of the

button up/down. To adjust the angle of

the seat cushion, press the front of the

button up/down.

●

If the engine is started while the seats are

being electrically adjusted, the adjustment

will stop.

Backrest further upright/further re-

clined: press the button forwards/back-

wards.

●

Never attach or place seat upholstery or

●

When changing user a warning will be

covers on the electric controls.

shown on the infotainment system's screen

during the time that the seat is moving to

the saved position. This movement can be

stopped by pressing the stop button on the

screen.

●

Never use upholstery or seat covers that

have not been explicitly authorised for the

seats of the vehicle.

The position will be saved automatically in

the CUPRA Connect Active user when the

ignition is switched off.

129

Operation

WARNING

Adjusting the headrests

Headrest

If travelling with the headrests removed or

improperly adjusted, the risk of severe or

fatal injuries in the event of accidents and

sudden braking or manoeuvres increases.

Introduction

The possibilities for the adjustment and dis-

assembly of the headrests are described be-

low. Always make sure that the seats are cor-

●

Always travel with the headrest correctly

installed and adjusted.

rectly adjusted page 13 .

›››

●

To decrease the risk of cervical injuries in

the event of an accident, adjust the head-

rest correctly based on your height, always

making sure that its upper edge is at the

same height as the top of the head, but

never below eye level. Keep the back of

your head always as close to the headrest as

possible and centred.

All seats are equipped with a headrest. The

central rear headrest is only intended for the

central seat of the rear bench. Therefore, do

not install it on any other seat.

Fig. 103 Front seat: headrest adjustment.

Correct adjustment of headrest

Adjust the headrest so that its upper edge is

at the same level as the top of your head and

under no circumstances below eye level.

Keep the back of your head always as close

to the headrest as possible.

●

Never adjust the headrest while the vehi-

cle is in motion.

●

Under no circumstances should the rear

passengers travel while the headrests are in

the non-use position.

Adjusting the headrest for short people

CAUTION

Lower the headrest completely, even if your

head is below its upper edge. In the lowest

position, there may be a small distance be-

tween the headrest and the backrest.

When assembling and disassembling the

headrests, do not let them meet the top

lining of the vehicle, the back rest of the

front seat or other parts of the vehicles. If

not, this could damage the vehicle.

Fig. 104 Rear headrest: headrest adjust-

ment.

Adjusting the height of the headrests

Adjusting the headrest for tall people

●

Grab the sides of the headrests with both

Push the headrest up as far as it will go.

hands and push upwards to the desired posi-

tion. To lower it, repeat the same action,

pressing the

Fig. 103

Fig. 104 but-

›››

ton on the side.

130

Seats and headrests

●

The headrest must lock correctly in one

Unlock the backrest page 132 .

›››

Seat functions

position.

Move the headrest upwards until it arrives

to the top.

Memory function

●

Press button Fig. 105

, while simulta-

›››

Removing and fitting the headr-

ests

neously pressing on the security hole

with

a flat screwdriver a maximum of 5 mm wide,

and remove the headrest.

●

Move the backrest until it engages properly

in Folding down and raising the rear

›››

seat backrest on page 133.

Fitting the rear headrests

Fig. 106 On the outer side of the driver's

seat: memory buttons.

To mount the external headrests, the corre-

sponding backrest must be partially folded

forward.

Memory buttons

●

Unlock the backrest page 132 .

›››

The memory buttons can be used to save

and turn on settings for the driver seat and

the exterior mirrors.

Fig. 105 Rear headrest: removal.

Insert the headrest bars into the guides

until they perceptibly engage. It should not

be possible to remove the headrest from the

backrest.

Removing and fitting the front headrests

●

Move the headrest upwards until it arrives

to the top.

Save the settings of the driver seat and the

exterior mirrors while driving forward

●

Move the backrest until it engages properly

●

Press the side button Fig. 103

and

›››

in Folding down and raising the rear

›››

●

Apply the electronic parking brake.

remove the headrest.

seat backrest on page 133.

●

Move the gearshift to the neutral position.

Switch the ignition on.

●

To refit, insert the headrest into the holes

in the backrest, pushing it down until it en-

gages.

WARNING

Adjust the driver seat and the exterior mir-

Remove the rear headrests only when it is

necessary to fit a child seat. After removing

a child seat, refit the headrest immediately.

rors.

Removing the rear headrests

●

Press  for longer than 1 second

Fig. 106.

›››

●

To remove the headrest, the corresponding

backrest must be partially folded forward.

Press the memory button in which to store

the settings within approx. 10 seconds. A

131

Operation -> Seats and headrests for Your Cupra Formentor SUV First Generation (2020-2024)

Related Topics

Popular Owner Manuals

Latest Owner Manuals