Operation
●
●
–
Do not spill liquids onto the socket.
The built-in overload disconnect func-
tion prevents any electrical devices
that require a high start-up current
from turning on. In this case, unplug
the electrical device's power supply and
re-try the connection after about 10
seconds.
LED on the power socket
Do not plug adapters or extension cords
Steady green
light:
The childproof lock is unlocked.
The socket is ready to operate.
into the 230 volt power socket. Otherwise,
the integrated child lock will be unlocked
and the power socket will operate.
The ignition is switched off, but
there is enough power available
to continue supplying the socket
with current for a maximum of 10
minutes. If the connector is un-
plugged before this time elapses,
the socket is disconnected and
cannot be used again until the ig-
nition is switched on again.
●
Do not insert conductive objects (a knit-
ting needle, for example) into the 230 volt
power socket.
Flashing green
light:
Note
●
The use of electrical appliances with the
WARNING
engine switched off will cause a battery dis-
charge.
The power socket works only when the ig-
nition is on. Improper use may cause seri-
ous injury or even fire. Children should
therefore not be left in the vehicle unatten-
ded if the button is also left behind. Other-
wise there is a possibility that they may be
injured.
There is an anomaly, e.g. discon-
nection due to a current surge or
overheating.
●
Should the connected appliance over-
Flashing red light:
heat, immediately switch it off and discon-
nect it from the socket.
●
Before switching the ignition on or off,
Disconnection due to overheating
unplug the appliances from the USB ports
to protect them from any damage caused
by fluctuations in voltage.
When the temperature exceeds a certain
value, the 230 volt socket inverter is auto-
matically disconnected. The disconnection
prevents overheating when the power con-
sumption of the connected devices is exces-
sive or the ambient temperature is very high.
The 230-volt power supply can be used once
again after a cooling time. First unplug the
connector of the connected device and
then plug it back in again. This prevents the
electrical device from being switched on
again if this is not wanted.
CAUTION
●
Some appliances may not work properly
Always use the correct type of plugs to
avoid damaging the sockets.
when connected to the 230 volt sockets
due to a lack of power (watts).
CAUTION
●
230 volt power socket:
–
Do not leave devices or connectors that
are too heavy (e.g. a transformer)
hanging directly from the power sock-
et.
–
–
Do not connect neon lamps.
WARNING
Only connect devices to the socket if
the device and socket voltage match.
The electrical system is under high voltage!
146
English 
