Starting and Driving -> Electric Drive Unit for Your Fiat 600 SUV Second Generation (2023-2026)

D : drive mode, low recuperation (first  
push)  
The vehicle will not shift into P if it is  
moving too fast. Stop the vehicle and  
shift into P.  
drive unit. Only shift into R after the vehicle  
has been stopped.  
B : regenerative braking (second push)  
The mode is shown in the instrument  
panel display (1) fig. 174.  
To shift into P, press button P. The  
LED on the button turns on.  
ELECTRIC DRIVE  
UNIT  
To shift out of P: Depress the brake  
pedal and select the desired mode.  
(Electric versions)  
167)  
Reverse gear R  
To shift into and out of R, the vehicle  
must be at standstill and the brake  
pedal has to be depressed.  
With the reverse gear engaged, the  
LED on the button turns on.  
53)  
OPERATION  
174  
F6S0178  
Neutral N  
In this mode, the propulsion system  
does not transfer torque to the wheels.  
To restart the propulsion system when  
the vehicle is already moving, use D  
only.  
The state of the Electric Driving Unit  
remains displayed on the instrument  
panel for a few seconds after switching  
off the ignition.  
173  
F6S0205  
Park mode P  
The vehicle uses an Electric Drive Unit  
with a 1-gear transmission. Push the  
buttons fig. 173:  
With the neutral engaged, the LED on  
the button turns on.  
This mode locks the front wheels. It is  
the recommended mode when starting  
the propulsion system because the  
vehicle cannot move easily.  
170)  
P : park position, wheels are locked,  
engage only when the vehicle is  
stationary, engaged automatically when  
driver's door is opened or engine is  
switched off  
Drive mode D  
With the D engaged, the LED on the  
button turns on.  
164) 169)  
52)  
The electric drive unit automatically  
shifts to P if  
54)  
the vehicle is stopped  
the driver's door is opened while the  
vehicle's speed is below 2 km/h  
R : reverse gear, engage only when the  
vehicle is stationary  
WARNING In slippery conditions,  
operate the vehicle in D for enhanced  
riding and handling performance.  
N : neutral  
146  
Regenerative braking mode B  
Regenerative braking generates  
electrical energy resulting from engine  
braking to charge the high-voltage  
battery. Regenerative power may be  
limited when the high-voltage battery is  
fully charged.  
IMPORTANT  
WARNING  
167) Never leave children unattended in  
the vehicle. Always remove the ignition key  
when leaving the vehicle and take it out  
with you.  
168) Never use P mode instead of the  
electric parking brake. Always engage the  
electric parking brake when parking the car  
to avoid the accidental movement of the  
vehicle.  
169) Do not leave the vehicle when the  
propulsion system is running, the vehicle  
may move suddenly. You or others can  
be injured. To be sure the vehicle will not  
move, even if you are on even ground,  
make sure the parking brake is applied and  
P is selected.  
170) Do not shift the Electric Drive Unit to  
N and do not stop the engine when driving  
on a downhill road. This type of driving  
is dangerous and reduces the possibility  
of intervening in the case of variation of  
the road traffic or surface. You risk losing  
control of your car and causing accidents.  
171) In the case of extreme temperatures  
or if the high-voltage battery is almost  
fully charged, the brake force of the  
regenerative braking may be temporarily  
reduced. If the braking force is not  
sufficient, the driver has to be prepared to  
use the brake pedal.  
52) If the car is on a gradient, always  
engage the electric parking brake BEFORE  
placing the Electric Drive Unit in P.  
53) Shifting into R while the vehicle is  
moving forward could damage the electric  
drive unit. Only shift into R after the vehicle  
has been stopped.  
54) If the vehicle seems to accelerate  
slowly or not respond when you try to go  
faster, do not continue your journey. The  
electric drive unit could be damaged.  
Consult a Fiat Dealership as soon as  
possible.  
55) Spinning the tyres or holding the  
vehicle in one place on a hill using only  
the accelerator pedal may damage the  
electric drive unit. If you are stuck, do not  
spin the tyres. When stopping on a hill, use  
the brakes to hold the vehicle in place.  
If B mode is selected, energy is  
regenerated when the accelerator  
pedal is lifted. In this mode, vehicle  
speed is significantly reduced by  
releasing the accelerator pedal, without  
operating the brake pedal.  
Use B mode when driving down steep  
hills, in deep snow, in mud or in stop-  
and-go traffic.  
171) 172)  
B can only be activated if D is selected.  
Press button B. The LED on the button  
turns on.  
To deactivate B, press button B.  
55)  
Deactivating the automatic  
operation of P mode for electric  
vehicles  
The procedure for the deactivation of  
the automatic operation of P mode also  
deactivates the automatic operation of  
the electric parking brake.  
172) While using regenerative braking,  
the brake lights do not illuminate. If the  
succeeding traffic is to be warned,  
depress the brake pedal.  
For this procedure, refer to the  
description of the automatic parking  
brake.  
147