Starting and Driving -> Speed Limit Recognition for Your Fiat 600 SUV Second Generation (2023-2026)

combined with the navigation system of  
Uconnect™ 10,25"/10,25" NAV.  
206) The system should be deactivated in  
the following situations: when changing a  
wheel or working near a wheel; towing or  
with a bicycle carrier on a towing device,  
especially with trailer not plugged in or not  
approved; adverse weather conditions;  
road with low grip (risk of aquaplaning,  
snow, ice); road works and toll areas;  
driving on racing circuits; driving on a  
rolling road.  
78) If the windscreen glass must be  
replaced due to scratches, chipping or  
breakage, contact exclusively a Fiat  
Dealership. Do not replace the windscreen  
on your own, risk of malfunction! It is  
advisable to replace the windscreen if it is  
damaged in the area of the camera.  
79) Do not tamper with nor operate on the  
camera. Do not close the openings in the  
aesthetic cover located under the interior  
rear view mirror. In the event of a failure of  
the camera, contact a Fiat Dealership.  
80) Do not cover the operating range of  
the camera with stickers or other objects.  
Also pay attention to other objects on the  
bonnet (e.g. a layer of snow) and make  
sure they do not interfere with the camera.  
TRAFFIC SIGN  
RECOGNITION  
Using the camera at the top of the  
windscreen, this system detects and  
reads speed limit signs and end of  
speed limit signs.  
If the function is activated and set  
as a widget in the Uconnect™  
10,25"/10,25" NAV, up to two speed  
limit signs including supplementary  
signs are displayed in the instrument  
panel display (1) fig. 202.  
WARNING  
75) The camera may have limited  
or absent operation due to weather  
conditions such as: heavy rain, hail, thick  
fog, heavy snow, formation of ice layers on  
the windscreen glass.  
SPEED LIMIT  
RECOGNITION  
76) Camera operation may also be  
compromised by the presence of  
dust, condensation, dirt or ice on the  
windscreen glass, by traffic conditions  
(e.g. cars that are driving not aligned  
with yours, car driving in a transverse or  
opposite way on the same lane, bend  
with a small radius of curvature), by  
road surface conditions and by driving  
conditions (e.g. off-road driving). Make  
sure the windscreen is always clean. Use  
specific detergents and clean cloths to  
avoid scratching the windscreen. The  
camera operation may also be limited or  
absent in some driving, traffic and road  
surface conditions.  
(where provided)  
207) 208) 209)  
1
81) 82) 83) 84) 85) 86) 87) 88)  
WARNING For more information, refer  
to the "Advanced Driver Assistance  
Systems (ADAS) recommendations"  
chapter in this section and "System  
limitations" in this chapter.  
202  
F6S0180  
If several speed limits are recognised,  
the vehicle may analyse and display the  
valid speed limit.  
When a traffic sign for a certain area,  
e.g. city or motorway, is recognised  
and the vehicle is fitted with a  
navigation system, the corresponding  
speed limit will also be displayed.  
Depending on the vehicle features,  
the Speed Limit Recognition uses the  
camera at the top of the windscreen  
(Traffic Sign Recognition) or the camera  
77) Projecting loads on the roof of the car  
may interfere with the correct operation of  
the camera. Before starting make sure the  
load is correctly positioned, in order not to  
cover the camera operating range.  
169  
If the system is activated but does not  
detect a speed limit sign, the following  
sign is displayed:  
Depending on version, two different  
systems are available.  
Version 1  
Using the camera at the top of the  
windscreen and the vehicle's integrated  
navigation system, this system provides  
speed limits and end of speed limits.  
If the function is activated and set  
as a widget in the Uconnect™  
10,25"/10,25" NAV, up to two speed  
limit signs including supplementary  
signs are displayed (1) fig. 204.  
205  
F6S0181  
If a speed limit is detected and the  
vehicle exceeds it for the first time  
by more than 5 km/h, the speed  
is displayed and flashes about 10  
seconds.  
203  
F6S0181  
If a speed limit is detected and the  
vehicle exceeds it for the first time  
by more than 5 km/h, the speed  
is displayed and flashes about 10  
seconds.  
Updating navigation map data  
1
To maintain the performance of the  
system, the navigation map should  
be kept updated via "Over-The-Air  
map updates". Further information are  
available in the paragraph "TomTom  
Services" in the "Multimedia" section.  
This system can be activated  
or deactivated in the vehicle  
personalisation through the  
Uconnect™ 10,25"/10,25" NAV.  
NOTE Specific speed limits, such as  
those for heavy goods vehicles, are  
not displayed. The display of the  
speed limit on the instrument panel is  
updated when passing a speed limit  
sign intended for cars (light vehicles).  
204  
F6S0180  
This system can be activated  
or deactivated in the vehicle  
personalisation through the  
Uconnect™ 10,25"/10,25" NAV.  
If the system is activated but does not  
detect a speed limit sign, the following  
sign is displayed:  
Version 2  
This system displays permanently  
speed limit information in the  
instrument panel display. If the function  
is activated and set as a widget in the  
Uconnect™ 10,25"/10,25" NAV,  
up to two speed limit signs including  
supplementary signs are displayed (1)  
fig. 204.  
SPEED LIMIT  
RECOGNITION WITH  
NAVIGATION SYSTEM  
(for versions/markets where provided)  
170  
Providing the speed limit information  
involves the following systems:  
camera at the top of the windscreen  
vehicle's integrated navigation  
system  
Operation conditions  
To provide country-specific speed  
limit information, the vehicle needs to  
identify the country it is currently in. If a  
corresponding country list is available  
in the instrument panel display, the  
respective country has to be selected  
manually. Otherwise, the country is  
automatically selected.  
telematics service  
If travelling on a road with no  
speed restrictions, e.g., on German  
motorways, the following sign is  
displayed:  
To get valid speed limit information,  
the vehicle's current position is sent via  
the telematics unit and is immediately  
deleted after processing. Tracking of  
the vehicle position is not possible at  
any time.  
207  
F6S0181  
If a new speed limit is provided,  
a confirmation chime is given.  
The confirmation chime can be  
activated or deactivated in the  
This is not impacted by the privacy  
settings of Uconnect™ 10,25"/10,25"  
NAV.  
vehicle personalisation through the  
Uconnect™ 10,25"/10,25" NAV.  
If the vehicle exceeds the speed  
limit, the speed limit displayed in the  
instrument panel display flashes and  
an audible signal is given after some  
time. Time of occurrence varies.  
Both flashing and audible signal are  
terminated after a few seconds. Due to  
legal requirements, the audible signal  
can only be deactivated in the vehicle  
personalisation until the next time the  
ignition is switched on. If the audible  
WARNING It is possible to report a  
permanent speed limit misinformation  
through the Manufacturer website.  
206  
F6S0182  
If the system is activated but does not  
detect a speed limit sign, the following  
sign is displayed:  
Updating data  
To maintain the performance of the  
system, the navigation map should  
be kept updated via "Over-The-Air  
map updates". Further information are  
available in the paragraph "TomTom  
Services" in the "Multimedia" section.  
signal is deactivated,  
a few seconds.  
illuminates for  
In case of a failure,  
illuminates  
permanently. Seek the assistance of a  
Fiat Dealership.  
171  
OTHER TRAFFIC SIGNS  
The system recognises other  
traffic signs (shared traffic zones,  
supplementary traffic signs) and  
displays them in the instrument panel  
display.  
This system can be activated  
or deactivated in the vehicle  
personalisation through the  
Uconnect™ 10,25"/10,25" NAV.  
Speed limit for  
vehicles with a  
gross vehicle  
weight or gross  
train weight less  
than 3.5 tonnes  
90 km/h (56 mph)  
(for example)  
SYSTEM LIMITATIONS  
The system does not take account of  
reduced speed limits, especially those  
imposed in the following cases:  
Atmospheric pollution  
Entry into a  
shared traffic  
zone  
Example:  
If the outside  
temperature is  
below 3°C: 30  
km/h (19 mph) (for  
example) with a  
"snowflake" symbol  
Suggested speed  
(calculated): 10  
mph or 20 km/h  
(depending on  
Speed limit in  
case of snow  
Example:  
Towing  
Driving with a space-saver type  
spare wheel or snow chains fitted  
Tyre repaired using the temporary  
puncture repair kit  
the units on the  
instrument panel)  
20  
Speed limit at  
certain times of  
the day  
If the wiper control  
stalk is in the  
"intermittent wipe"  
or "automatic wipe"  
position (in order  
to activate the  
Young drivers  
30 km/h (19 mph)  
(for example) with a  
"clock" symbol  
The system may not operate properly  
when:  
Speed limit when  
raining  
Example:  
Example:  
Driving on winding or hilly roads.  
During nighttime driving.  
Driving with snow chains.  
Driving with a trailer.  
The area of the windscreen, where  
the front camera is located, is not  
clean or affected by foreign items, e.g.  
stickers.  
The visibility is limited because of the  
weather, such as fog, rain, or snow.  
The sun is shining directly into the  
camera lens.  
rain sensor): 110  
km/h (68 mph) (for  
example)  
If an approved  
Speed limit when  
towing  
towing device is  
fixed to the vehicle:  
90 km/h (56 mph)  
(for example)  
Speed limit  
applicable over a  
certain distance  
Example:  
Traffic signs are completely or  
partially covered or difficult to discern.  
Traffic signs are incorrectly mounted  
or damaged.  
208  
F6S0183  
70 km/h (43 mph)  
(for example)  
210)  
172  
Traffic signs do not comply with the  
Vienna Convention on Road Signs and  
Signals.  
HIGHWAY DRIVER  
ASSIST (LEVEL  
2 AUTONOMOUS  
DRIVING)  
driver from full responsibility for vehicle  
operation.  
82) Functionality may be limited or the  
system may not work if the sensor is  
obstructed.  
83) The system may have limited operation  
or not work at all in weather conditions,  
such as heavy rain, hail, thick fog and low  
temperatures. Strong light contrasts can  
influence the recognition capability of the  
sensor.  
84) The area surrounding the sensor must  
not be covered with stickers or any other  
object.  
85) Do not tamper or perform any  
operations in the area of the windscreen  
glass directly surrounding the sensor.  
86) Clean the windscreen glass from  
foreign matters such as bird droppings,  
insects, snow or ice. Use specific  
detergents and clean cloths to avoid  
scratching the windscreen.  
87) The units for the speed limit (mph or  
km/h) depend on the country you are  
driving in. This should be taken into  
account to ensure you observe the speed  
limit. For the system to work properly  
when changing countries, the speed unit  
of the instrument panel must match that of  
the country you are driving in.  
88) Automatic sign reading is a driving aid  
system and does not always display the  
correct speed limits. The speed limit signs  
present on the road always take priority  
over those displayed by the system. The  
system is designed to detect signs that  
conform to the Vienna Convention on road  
signs.  
The navigation map data is outdated.  
(where provided)  
IMPORTANT  
This system automatically adjusts the  
speed and corrects the trajectory of  
the vehicle, using the Adaptive Cruise  
Control with Stop&Go in conjunction  
with the Advanced Lane Keep Assist.  
These two functions must be activated  
and in operation.  
207) The system only detects preset traffic  
signs if the minimum visibility conditions  
and distance from the sign are met.  
208) The system is an aid for driving and  
does not relieve the driver of responsibility  
for driving the car. Always respect the  
highway code of the country you are  
driving in.  
209) When the system is active, the driver  
is responsible for controlling the car and  
monitoring the system, and must be ready  
to intervene as appropriate if necessary.  
210) The actual traffic sign always takes  
priority over the traffic sign displayed in the  
instrument panel display.  
This system is especially suitable for  
driving on motorways and main roads.  
For more information on Adaptive  
Cruise Control and Advanced Lane  
Keep Assist, refer to the corresponding  
chapters in this section.  
211)  
WARNING For more information, refer  
to the "Advanced Driver Assistance  
Systems (ADAS) recommendations"  
chapter in this section.  
WARNING  
81) The system is intended to help the  
driver within a defined speed range to  
discern certain traffic signs. Do not ignore  
traffic signs which are not displayed by the  
system. The system does not discern any  
other than the conventional traffic signs  
that might give or end a speed limit. Do  
not let this special feature tempt you into  
taking risks when driving. Always adapt  
speed to the road conditions. The driver  
assistance systems do not relieve the  
173