Starting and Driving -> Electrified Dual Clutch Automatic Transmission for Your Fiat 600 SUV Second Generation (2023-2026)

Release the brake pedal and switch  
on ignition.  
Depress and hold the brake pedal  
Remove the ignition key from the ignition  
switch or switch off ignition on vehicles  
with STOP START ENGINE button. Turn  
the steering wheel until the steering wheel  
lock is felt to engage.  
and push the switch  
.
Release the brake pedal and switch  
off ignition.  
163) Pull switch  
for a minimum of  
1 second until control indicator  
The deactivation will be confirmed by a  
message and will be cancelled after 15  
minutes. To previously return to normal  
operation, depress the brake pedal and  
start the engine.  
illuminates constantly and electric parking  
brake is applied. The electric parking brake  
operates automatically with adequate  
force. Before leaving the vehicle, check the  
electric parking brake status.  
170  
F6S0215  
Push the buttons fig. 170:  
FAULT  
Failure mode of electric parking brake  
ELECTRIFIED  
DUAL CLUTCH  
AUTOMATIC  
(P) park position, wheels are locked,  
engage only when the vehicle is  
stationary, engaged automatically when  
driver's door is opened or engine is  
switched off  
is indicated by a lamp  
and by a  
message displayed in the instrument  
panel display.  
TRANSMISSION  
The lamp  
flashes: electric parking  
(Hybrid versions)  
(R) reverse gear, engage only when the  
vehicle is stationary  
brake is not fully applied or released.  
When continuously flashing, release  
electric parking brake and retry  
applying.  
6-speed electrified dual-clutch  
automatic gearbox with push selector  
for hybrid vehicles. It also offers a  
manual mode with gear changes via  
control paddles located behind the  
steering wheel. It includes the 48 V  
electric motor, which improves the  
performance of the petrol engine,  
reduces fuel consumption and drives in  
all-electric.  
(N) neutral  
(D) automatic mode (first push)  
(M) manual mode (second push)  
The mode or selected gear is shown  
in the instrument panel display (1)  
fig. 174.  
IMPORTANT  
162) Do not park the vehicle on an easily  
ignitable surface. The high temperature  
of the exhaust system could ignite the  
surface. Always apply the parking brake.  
If the vehicle is on a level surface or uphill  
slope, set the PRND command to position  
P. If the vehicle is on a downhill slope,  
set the PRND command to position P.  
Turn the front wheels towards the kerb.  
Close the windows. Switch off the engine.  
GEAR SELECTION  
164) 165) 166)  
50)  
142  
To shift into (P), press button (P). The  
LED on the button turns on.  
Manual mode M  
With the (M) engaged, the LED on the  
button turns on.  
CHARGE  
ECO  
POWER  
km/h  
P
To shift out of (P): Depress the brake  
pedal and select the desired mode.  
O
In this mode, it is possible to change  
gears manually using steering the  
wheel paddles.  
1
Reverse gear R  
To shift into and out of (R), the vehicle  
must be at standstill and the brake  
pedal has to be depressed.  
With the reverse gear engaged, the  
LED on the button turns on.  
51)  
Steering-mounted controls  
0
1/ 2  
1
In mode (M) or (D), the steering-  
mounted control paddles can be used  
to change gear manually. They cannot  
be used to select neutral or to engage  
or disengage reverse gear.  
192 km 51%  
800km  
171  
F6S0262  
In automatic mode, the driving  
programme is indicated by (D).  
Neutral N  
MANUAL MODE  
In manual mode, (M) and the number of  
the selected gear is indicated.  
In all-electric driving, the gear engaged  
is not indicated.  
In this mode, the propulsion system  
does not transfer torque to the wheels.  
To restart the propulsion system when  
the vehicle is already moving, use (D)  
only.  
Manual mode (M) can be activated  
pushing the button (D) in each driving  
situation and speed.  
The selected gear is indicated in the  
instrument panel display.  
The state of the gearbox remains  
displayed on the instrument panel for  
a few seconds after switching off the  
ignition.  
With the neutral engaged, the LED on  
the button turns on.  
If a higher gear is selected when vehicle  
speed is too low, or a lower gear when  
vehicle speed is too high, the shift  
is not executed. This can cause a  
message in the instrument panel  
display.  
When (N) is selected and ignition is  
switched off, (P) is engaged after a  
short time  
Park position P  
This mode locks the front wheels. (P) is  
automatically engaged when ignition is  
switched off.  
Automatic mode D  
With the (D) engaged, the LED on the  
button turns on.  
In manual mode, no automatic shifting  
to a higher gear takes place at high  
engine revolutions.  
The vehicle automatically shifts into (P)  
if  
the vehicle is stopped  
WARNING In slippery conditions,  
operate the vehicle in (D) for enhanced  
riding and handling performance.  
the driver's door is opened while the  
vehicle's speed is below 2 km/h  
The vehicle will not shift into (P) if it is  
moving too fast. Stop the vehicle and  
shift into (P).  
143  
The electric motor has the following  
features:  
OPERATION  
Only appropriate mode change  
instructions are validated. With the  
engine running, if it is necessary to  
depress the brake pedal to change  
modes, an alert message will be  
displayed on the instrument panel.  
Provide an additional torque to the  
gearbox,  
Recover the kinetic energy of the  
deceleration phases, converting it into  
electrical energy, which can be used  
for traction or for the power supply of  
electrical accessories installed on the  
vehicle.  
Recharge the 48 V traction battery  
when the state of charge is too low.  
Provide all-electric driving only.  
These features are achieved through  
the following functions set of automatic  
operating mode:  
WARNING With the engine running  
and the brakes released, if (R), (D) or  
(M) is selected, the vehicle moves off,  
even without pressing the accelerator  
pedal. Never depress the accelerator  
and brake pedals at the same time: risk  
of damage to the gearbox!  
172  
F6S0105  
Press button (M).  
Pull steering wheel paddles to select  
gears manually fig. 172.  
Pull right paddle + to shift to a higher  
gear.  
e-Boost  
e-Creeping  
e-Launch  
e-Queueing  
e-Parking  
WARNING At speeds below 2 mph,  
opening the driver’s door will engage  
mode - risk of sudden braking!  
Pull left paddle - to shift to a lower  
gear.  
Multiple pulls allow gears to be  
skipped.  
WARNING In the event of battery  
failure, it is essential to place the  
chock(s) supplied with the tool kit  
against one of the wheels to immobilise  
the vehicle.  
A manual operating mode is also  
available to activate/deactivate the  
restart of the petrol engine while  
driving: the e-Auto mode.  
Gear shift indication  
The symbol or with a number  
beside it is indicated when gearshifting  
is recommended for fuel saving  
reasons. Shift indication.  
WARNING When mode P or N is  
selected on the automatic gearbox, the  
noise level in the engine compartment  
may increase due to the start of the  
charging phase of the traction battery:  
this is normal and does not represent a  
malfunction.  
Electric motor  
NOTE If you open the driver's door  
while mode is engaged, an audible  
signal will sound and mode will be  
engaged. The audible signal stops  
when the driver's door is closed.  
The electric motor included in the  
automatic gearbox, which is used for  
the first start, provides 12 V power  
supply via the DC/DC converter and  
provides electric assistance to the  
petrol engine.  
144  
SPECIAL ASPECTS OF  
AUTOMATIC MODE  
e-Parking  
NOTE Using the steering wheel  
paddles also causes the restarting  
of petrol engine. If high traction is  
required, the driver can deactivate the  
e-Auto mode using the touch screen  
menu.  
This function allows parking  
manoeuvres to be carried out at  
reduced speed with the help of the  
electric motor when the mode D or R of  
the automatic gearbox is selected.  
These functions respond to common  
driving situations where the electric  
motor is available to provide additional  
power or zero-emission driving.  
NOTE These functions are only  
available if the traction battery is  
sufficiently charged. These five  
functions cannot be deactivated.  
e-Boost  
This function allows simultaneous  
operation of the petrol engine and the  
electric motor, combined with the  
automatic gearbox.  
IMPORTANT  
164) Never use P mode instead of the  
electric parking brake. Always engage the  
electric parking brake when parking the car  
to avoid the accidental movement of the  
vehicle.  
165) If the P position is not engaged, the  
car could move and injure people. Before  
leaving the car, make sure that the PRND  
command is in position P and that the  
parking brake is engaged.  
e-Launch  
With the petrol engine off, this function  
allows the vehicle to run in electric  
mode without affecting performance.  
By depressing the accelerator pedal,  
the vehicle starts to drive as soon as  
the mode D or R of the automatic  
gearbox is selected.  
By fully depressing the accelerator  
pedal ("kick-down" function), when  
the traction battery is fully charged,  
it is possible to exceed the torque  
of the petrol engine alone, thanks to  
the additional torque provided by the  
electric motor.  
166) Do not shift the automatic  
NOTE Repeated use of the brake pedal  
causes the restart of petrol engine to  
provide braking assistance.  
e-Creeping  
transmission to N and do not stop the  
engine when driving on a downhill road.  
This type of driving is dangerous and  
reduces the possibility of intervening in  
the case of variation of the road traffic or  
surface. You risk losing control of your car  
and causing accidents.  
With the petrol engine off, by releasing  
the brake pedal, this function allows  
the vehicle to be moved forward or  
backward in electric mode without  
having to depress the accelerator  
pedal, as soon as the mode D or R of  
the automatic gearbox is selected.  
Special aspects of  
manual mode  
The gearbox only changes from one  
gear to another if the vehicle speed and  
engine speed conditions permit.  
The petrol engine can also be switched  
off in manual mode when stopped in  
traffic or when the accelerator pedal is  
released. The all-electric potential of the  
driving mode used (Normal or Eco) is  
also retained.  
WARNING  
e-Queueing  
This function makes it possible to  
follow a queue of vehicles with  
several stops followed by restarts of  
the vehicle, using the e-Creeping,  
e-Launch and electric driving modes.  
50) If the car is on a gradient, always  
engage the electric parking brake BEFORE  
placing the automatic transmission in P.  
51) Shifting into R while the vehicle is  
moving forward could damage the electric  
145