Starting and Driving -> Speed Limiter for Your Fiat 600 SUV Second Generation (2023-2026)

STEERING-MOUNTED  
CONTROLS  
pressing (3) again temporarily pauses  
the function  
SPEED LIMITER  
(where provided)  
ADJUSTING THE SPEED  
SETTING  
179) 180) 181)  
SET+  
To change the speed setting:  
for steps of +/- 1 km/h (1 mph),  
make successive short presses  
upwards/downwards on (2) to  
increase/decrease  
WARNING For more information, refer  
to the "Advanced Driver Assistance  
Systems (ADAS) recommendations"  
chapter in this section.  
OK  
_
for steps of +/- 5 km/h (5 mph),  
press and hold upwards/downwards  
on (2) to increase/ decrease  
When the function is activated, it is  
possible to modify the Speed Limit  
setting based on the speed suggested  
by the Traffic Sign Recognition  
function, as shown on the instrument  
panel:  
The Speed limiter prevents the vehicle  
from exceeding a preset maximum  
speed.  
180  
JJ000612  
The maximum speed can be set at  
speeds above 30 km/h.  
(1) Activate the speed limiter at the  
previously saved speed setting. Use  
the speed suggested by the Road  
signs recognition  
The driver can accelerate the vehicle  
up to the preset speed. Deviations  
from the limited speed may occur when  
driving downhill.  
(2) Increase/Decrease the speed  
setting  
When passing the sign:  
The preset speed can be exceeded  
temporarily by pressing the accelerator  
pedal firmly.  
(3) Switch on/pause the speed limiter at  
the previously saved speed setting  
(4) Speed limiter ON/OFF  
press (1) OK to save the  
suggested speed. This value  
is then immediately shown as  
the new speed setting on the  
instrument panel  
The status and preset speed limit are  
displayed in the instrument panel  
display.  
SWITCHING ON/PAUSING  
press (4) fig. 180 to select the speed  
limiter mode; the function is paused  
(the speed shown on the instrument  
panel display is grey).  
After passing the sign:  
Press (1) OK. The message  
"OK?" (1) fig. 181 is displayed to  
confirm the request to save  
Press (1) OK again to save the  
suggested speed. The new speed  
setting value is displayed on the  
instrument panel  
if the limit speed setting is  
suitable (most recent speed setting  
programmed in the system), press (3)  
or (1) OK to switch the speed limiter on  
(the speed is green)  
152  
deactivated and the displayed speed  
setting flashes  
DISPLAY VISUALIZATION  
release the accelerator pedal to  
return to below the speed setting  
When the vehicle speed returns to the  
speed setting level, the speed limiter  
operates again: the speed setting  
display becomes fixed again.  
1
OFF  
Press (4): the speed limiter information  
display disappears.  
181  
F6S0179  
MALFUNCTION  
In the event of a malfunction, dashes  
are displayed flashing and then fixed  
(orange) instead of the speed setting.  
Have it checked by a Fiat Dealership.  
IMPORTANT  
182  
F6S0252  
179) While driving with the device active,  
never move the gear lever to neutral or the  
PRND command to N.  
Depending on the Speed limiter status,  
different notifications are shown in the  
instrument panel display, fig. 182:  
(1) Speed selection  
180) In case of a malfunction or failure of  
the device, contact a Fiat Dealership.  
181) On a steep descent or in the event  
of sharp acceleration, the speed limiter  
will not be able to prevent the vehicle from  
exceeding the speed setting. If necessary,  
apply the brakes to control your vehicle’s  
speed.  
(2) Speed limiter activated  
(3) Speed limited paused  
TEMPORARILY  
EXCEEDING THE SPEED  
SETTING  
fully depress the accelerator pedal.  
The speed limiter is temporarily  
153