Convenience features
Limitations of High Beam Assist
High Beam Assist may not work prop-
erly in the following situations:
• Light from an oncoming or front vehi-
cle is not detected because of lamp
damage, or because it is hidden from
sight, etc.
Information
i
For more information on the limita-
tions of the front view camera, refer to
the “Forward Collision-Avoidance
Assist (FCA)” section in chapter 7.
• Headlight of an oncoming or front
vehicle is covered with dust, snow or
water.
• A front vehicle’s headlights are off but
the fog lights are on and etc.
• There is a lamp that has a similar
shape as a vehicle’s lamp.
• Headlights have been damaged or
not repaired properly.
• Headlights are not aimed properly.
• Driving on a narrow-curved road,
rough road, uphill or downhill.
• Vehicle in front is partially visible on a
crossroad or curved road.
• There is a traffic light, reflecting sign,
flashing sign or mirror ahead.
WARNING
• At times, High Beam Assist may
not work properly. The function is
for your convenience only. It is the
responsibility of the driver for safe
driving practices and always check
the road conditions for your safe-
ty.
• When High Beam Assist does not
operate normally, change the
headlight
between high beam and low beam.
position
manually
• High Beam Assist may not operate
for 15 seconds after the vehicle is
started, or the front view camera is
initialized.
• There is a temporary reflector or flash
ahead (construction area).
• The road conditions are bad such as
being wet, iced or covered with snow.
• A vehicle suddenly appears from a
curve.
• The vehicle is tilted from a flat tire or
is being towed.
• Light from an oncoming or front vehi-
cle is not detected due to obstacles in
the air such as exhaust fume, smoke,
fog, snow, or water spay or blizzard
on the road, or fogging in the lamp,
etc.
5-48
English 
