08
CAUTION
NOTICE
Do not let the compressor run for
more than 10 minutes, otherwise the
device will overheat and may be
damaged.
Tyre pressure sensor
(if equipped with TPMS)
The sealant on the tyre pressure
sensor and wheel should be removed
when you replace the tyre with a new
one and inspect the tyre pressure
sensors. We recommend that you
get this done at a HYUNDAI autho-
rised repairer.
Information
i
The pressure gauge may show higher
than actual reading when the compres-
sor is running. To get an accurate tyre
reading, the compressor needs to be
turned off.
Information
i
When reinstalling the repaired or
replaced tyre and wheel on the vehicle,
tighten the wheel lug nut to 11-13
kgf·m (79-94 lbf·ft).
CAUTION
If the inflation pressure is not main-
tained, drive the vehicle a second
time, refer to Distributing the seal-
ant. Then repeat steps 1 to 4.
Use of the Tire Mobility Kit may be
ineffectual for tyre damage larger
than about 0.24 in. (6 mm ).
We recommend that you contact a
HYUNDAI authorised repairer if the
tyre cannot be made roadworthy
with the Tyre Mobility Kit.
WARNING
The tyre inflation pressure should
meet the standard “TYRES AND
WHEELS” in Chapter 2 or “Tyre
Inflation Pressure Standard Label”
on the B pillar of the driver’s seat.
If it is not, do not continue driving.
Call for road side service or towing.
8-31
English 
