[ Edit: 2014/ 11/ 7 Model: T32-A ]
1. If the booster battery is in another vehicle
*
B
,
position the two vehicles
*
A
and
*
B
to bring the
batteries into close proximity to each other.
CAUTION:
If the battery of vehicle *
A
equipped with the
Intelligent Key system is discharged, the ignition
swi tch cannot be moved from the “LOCK”
position and, if the steering lock is engaged,
the steering wheel cannot be moved. Connect
the jumper cables to the booster vehicle
*
B
before turning or pushing the ignition switch and
disengaging the steering lock.
2. Apply the parking brake.
3. Continuously Variable Transmission (CVT) model:
Move the shift lever to the “P” (Park) position.
Manual Transmission (MT) model: Move the shift
lever to the “N” (Neutral) position.
4. Switch off all unnecessary electrical systems
(headlights, heater, air conditioner, etc.).
5. Place the ignition switch in the “LOCK” position.
6. Remove the vent caps, if equipped, on the battery.
7. Cover the battery with a firmly wrung out moist
cloth to reduce the hazard of an explosion.
8. Connect the jumper cables in the sequence as
illustrated (
*
1
,
*
2
,
*
3
,
*
4
).
CAUTION:
. Always connect positive + to positive + and
negative 7 to body ground, NOT to the
battery’s negative 7.
. Be sure that the jumper cables do not touch
moving parts in the engine compartment.
. Be sure that the jumper cable’s clamps do
not contact any other metal.
9. Start the engine of the booster vehicle
*
B
and let
it run for a few minutes.
10. Depress the accelerator pedal of the booster
vehicle
*
B
at about 2,000 rpm.
11. Start the engine of the jumped vehicle
*
A
in the
normal manner.
CAUTION:
Never keep the starter motor engaged for more
than 10 seconds. If the engine does not start
right away, place the ignition switch “OFF” and
wait at least 10 seconds before trying again.
12. After the engine is started, carefully disconnect
the jumper cables in the opposite sequence from
that illustrated (
*
4
,
*
3
,
*
2
,
*
1
).
13. Remove and dispose of the cloth as it may be
contaminated with corrosive acid.
14. Replace the vent caps, if removed.
NOTE:
. For model with Stop/Start System or Idling
Stop System, use the special battery that is
enhanced in regard to the charge-discharge
capacity and life performance. Avoid using a
non-special battery for the Stop/Start Sys-
tem or Idling Stop System, as this may cause
early deterioration of the battery or a mal-
function of the Stop/Start System or Idling
Stop System. For the battery, it is recom-
mended to use Genuine NISSAN parts. For
more information, contact a NISSAN dealer.
. For model with Stop/Start System or Idling
Stop System, it may take some time until
Stop/Start System or Idling Stop System
activates when the battery is replaced or the
battery terminal is disconnected for ex-
tended periods and then reconnected.
In case of emergency 6-9
Condition: 'Except for China'/
English 
