北米Model "A2650BE-A" EDITED: 2025/ 6/ 27
– Unlock using the PIN Code Ac-
cess.
The flashing of the security indicator light
will then change slowly (once approxi-
mately every 3 seconds from twice
approximately every 2 seconds), indicat-
ing that the alarm system has been
disarmed.
Emergency disarming
s02af0501
If you cannot disarm the system using the
access key fob (i.e., the transmitter is lost,
broken or the transmitter battery is too
weak), you can disarm the system without
using the access key fob.
The system can be disarmed if you turn
the ignition switch from the “OFF” position
to the “ON” position with a registered key/
access key fob.
NOTE
If the access key fob battery is dis-
charged, perform the procedure de-
scribed in “Switching Power Status”
�P452. In such a case, replace the
battery immediately. Refer to “Replacing
Battery of Access Key Fob” �P507.
ALARM SYSTEM SETTING
s02af11
To change the setting of your vehicle’s
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system. Refer to
“Disarming the System” �P137.
2. Sit in the driver’s seat and shut all
doors, the rear gate and engine hood.
3. Turn the ignition switch to the “ON”
position.
4. Hold down “
” of the driver’s power
door locking switch, open the driver’s
door within the following 1 second,
and wait 10 seconds without releasing
the switch. The setting will then be
changed as follows.
Setting sta-
tus
Instrument cluster
display
Horn
Activate AL ON Once
Deactivate AL OFF
Twice
NOTE
You may have the above setting change
done by your SUBARU dealer.
IF YOU HAVE ACCIDENTALLY
TRIGGERED THE ALARM SYS-
TEM
s02af03
To stop the alarm
s02af0301
Do any of the following operations:
. Press any button on the access key
fob.
. Turn the push-button ignition switch to
the “ACC” position.
NOTE
Only registered keys will stop the alarm. If
the immobilizer transponder is not regis-
tered, the alarm will not stop.
KEYS AND DOORS
138
English 
