北米Model "A2650BE-A" EDITED: 2025/ 6/ 27
the power door locking switch. If a rear
door is unlocked from the inside door
lever then the door is opened and
closed, the Key lock-in prevention
function will be triggered. All doors will
be unlocked, the Key lock-in preven-
tion warning indicator “
” will appear
and the warning chime will also sound.
KEY LOCK-IN PREVENTION
FUNCTION
s02ac06
All the doors will not lock when the power
door locking switch is pushed with the
driver’s door open while the ignition
switch is in the “ACC” or “ON” position.
NOTE
. When leaving the vehicle, make sure
you are holding the key before locking
the doors.
. When getting out of the vehicle from a
rear door, make sure to unlock all the
doors by pushing the unlock side of
the power door locking switch.
. When getting out of the vehicle from a
rear door, make sure to unlock all the
doors by pushing the unlock side of
the power door locking switch. If a rear
door is unlocked from the inside door
lever then the door is opened and
closed, the Key lock-in prevention
function will be triggered. All doors will
be unlocked, the Key lock-in preven-
tion warning indicator “
” will appear
and the warning chime will also sound.
. The factory setting (default setting) for
this function is set as “operational”.
This function’s operational/non-op-
erational setting can be changed by a
SUBARU dealer. Contact a SUBARU
dealer for details.
Non-operation of key lock-in
prevention function
s02ac0602
When the system is set so that it does not
operate, the doors are locked by the
following operation.
. If the lock lever is turned to the front
(“LOCK”) position with the driver’s
door open and the driver’s door is then
closed with the lock lever in that
position, the driver’s door is locked.
. If the emergency key is used to lock
the driver’s door from the outside of
the vehicle, the door is locked.
BATTERY DRAINAGE REDUC-
TION FUNCTION
s02ac03
Under various conditions, lights inside the
vehicle will automatically turn off to
reduce the risk of discharging the battery.
Battery drainage reduction
function for various conditions
s02ac0302
This function will enter standby mode
when the ignition switch is turned to the
“OFF” position.
If the following actions are not performed
within 10 minutes, while the function is in
standby mode, any room lights that are on
will automatically turn off.
Turning off
lights
– Map light
– Dome light
– Ignition switch light
– Cargo area light
– Rear gate light*
1
– Vanity mirror light
– Door step lights
Actions
– Turn the ignition switch to the “ACC”
or “ON” position.
– Open or close the doors, including
the rear gate.
– Push the unlock button on the
access key fob.
– Hold the front door handle and
unlock it while holding the access
key fob.
– Come close to the vehicle that the
front door was locked while holding
the access key fob (if OFF delay
timer setting for period of time is not
off).
– Push the panic button on the access
key fob.
*1: If equipped
Perform the action in the above table to
illuminate the lights again when the
battery drainage reduction function is
active.
– CONTINUED –
KEYS AND DOORS
135
2
English 
