北米Model "A2650BE-A" EDITED: 2025/ 6/ 27
Touch sensors are attached on the left
and right edges of the rear gate. If the
touch sensors detect fingers, baggage,
etc. while closing by the power rear gate
function, an electronic chirp will sounds 3
times and the rear gate will open auto-
matically.
NOTE
When the rear gate is opened using the
reverse function, it will be opened fully or
to the height registered in the memory
function.
REAR GATE DROP PREVEN-
TION FUNCTION
s02au08
If, while fully opened via the power rear
gate function, the rear gate is lowered, the
rear gate drop prevention function will
apply braking to the rear gate so that it
prevents a rapid closure of the rear gate.
NOTE
If you close the rear gate manually just
after the rear gate is fully opened using
the power rear gate function, the rear gate
drop prevention function will detect a
rapid closure of the rear gate and apply
braking to the rear gate. In this case, this
is not a malfunction.
SELECTING AUDIBLE SIGNAL
OPERATION
s02au09
Using an electronic chirp, the power rear
gate will give you an audible signal before
starting its operation. If desired, the
audible signal can be turned off by a
SUBARU dealer. Consult your SUBARU
dealer for details.
You can also turn the audible signal off by
operating the center information display.
For details, refer to “Vehicle” �P206.
The ON/OFF setting of the audible signal
also works as the audible signal settings
for the “remote keyless entry system” and
the “keyless access with push-button
start system”. However, for the electronic
chirp such as that caused by “Reverse
Function” �P147, it cannot be set as non-
operational.
INITIALIZATION OF POWER
REAR GATE
s02au10
If the power rear gate detects some
abnormality while operating, an electronic
chirp will sound and the power rear gate
operation will be automatically stopped in
either opening or closing position. In this
case, the system needs to be initialized in
the following order to restart the function
properly.
If the power rear gate is closed
s02au1001
1. Keep pressing the rear gate opener
button until it is unlocked (for approxi-
mately 5 seconds) and lift up the rear
gate.
S_204645-W
Rear gate opener button
2. Pull down the rear gate until it starts to
close automatically. The system will
be initialized once the gate is fully
closed.
3. Operate the power rear gate and
check that the function operates
properly.
If the power rear gate is opened
s02au1002
1. Pull down the rear gate until it starts to
close automatically. The system will
be initialized once the gate is fully
closed.
If the rear gate will not close comple-
KEYS AND DOORS
148
English 
