北米Model "A2650BE-A" EDITED: 2025/ 6/ 27
Unlocking
s02ap2103
Perform steps (1) to (5) of step 5
described in “Registration for a PIN
code”.
NOTE
. You cannot unlock by PIN Code
Access in the following cases.
– When the access key fob is within
the operating ranges
– When the ignition switch is in the
“ACC” or “ON” position
. If you make an operation error during
the unlocking procedure, start over
with the unlocking procedure after
waiting for 5 seconds or longer.
. To protect your vehicle from theft, a
buzzer will sound if incorrect PIN
codes are entered five times continu-
ously. If this occurs, you cannot unlock
the doors by PIN Code Access for 5
minutes.
POWER SAVING FUNCTION
s02ap23
To protect the access key fob battery and
the vehicle battery, the keyless access
function will be disabled as follows.
. When the keyless access function and
the remote keyless entry system have
not been used:
(1) 5 days after the push-button igni-
tion switch has been turned off,
communication between the an-
tennas and the access key fob will
be stopped.
(2) 9 days after step (1), the sensors
(both lock sensor and unlock
sensor) on the front passenger’s
door will be disabled.
. When the access key fob has been left
in the operating range for 10 minutes
or longer while all doors are locked,
the keyless access function will be
disabled.
Recovery from power saving
mode
s02ap2301
When one of the following operations is
performed, the keyless access function
will be recovered.
. Unlock by gripping the door handle
(only when the sensors on the front
passenger’s door are not disabled) or
pressing rear gate opener button on
the rear gate.
. Lock or unlock by the remote keyless
entry system.
. Open a door and then close it.
. Turn the push-button ignition switch to
the “ON” position.
POWER SAVING FUNCTION OF
ACCESS KEY FOB
s02ap26
This function stops the access key fob
from receiving signals and helps minimize
the battery consumption of the access
key fob.
1. Press the “
” button twice while
holding the “
” button.
2. Confirm that the LED indicator blinks 4
times to notify that the setting is
complete.
S_204473-W
LED indicator
When the access key fob is in the power
save mode, the keyless access function
and push-button start system will not be
available. To cancel the power save
mode, press one of the buttons on the
– CONTINUED –
KEYS AND DOORS
125
2
English 
