北米Model "A2650BE-A" EDITED: 2025/ 6/ 27
MANUAL OPERATION
s02au04
Opening the rear gate:
Lift the rear gate up to the midway
position. The rear gate will automatically
open from the midway position to the fully
open position.
Closing the rear gate:
S_204657-W
Pull down the rear gate when the rear
gate is opened. The rear gate will close
automatically.
This function is disabled as the factory
default setting. To use the function, it must
be enabled. Consult your SUBARU
dealer to have this function set to enabled
or disabled. When opening and closing
the rear gate with this function disabled,
make sure to use the power rear gate by
operating the button.
The rear gate can be lowered easily if you
pull down on the inside handle as shown
in the illustration.
CAUTION
. Never attempt to close the rear
gate by grabbing or pressing on the
outer metal surface or damage
may result.
. Always use the inside handle to
avoid damaging the exterior sur-
face of the gate.
NOTE
. If the rear gate is moved slowly, it may
not operate automatically open or
close.
. When leaving the vehicle, make sure
that all doors and the rear gate are
completely locked.
MEMORY FUNCTION
s02au06
The preferred rear gate height can be
registered.
Registration of the rear gate height:
1. Open the rear gate and stop it at the
preferable height.
2. Press and hold the power rear gate
button to register the height.
S_204658-W
Power rear gate button
An electronic chirp sounds for confirma-
tion.
The rear gate will stop at the registered
position when the memory function is on.
NOTE
. Register the rear gate height to turn on
the “Power Rear Gate Height Mem-
ory” automatically. Refer to “Vehicle”
�P206.
. To change the registered height, per-
form the registering procedure again.
. It is possible to register the height from
approximately 2 in (5 cm) or more from
the completely closed position.
KEYS AND DOORS
146
English 
