07 Driver support
This symbol indicates that
you are approaching a vehi-
cle ahead.
Adaptive Cruise Control – setting
speed
NOTE
If one of the Adaptive Cruise Control
buttons is pressed for more than
approximately one minute, ACC will be
deactivated. The engine must then be
switched off and restarted to reset
ACC.
•
•
Setting a speed
Once ACC has been put in standby mode:
ACC will switch from main-
taining a set speed to main-
taining a set distance from
that vehicle.
In some situations Adaptive Cruise
Control cannot be put in active mode.
Cruise control Unavailable is shown
in the display, see Adaptive Cruise
Control – symbols and messages
(p. 195).
When this happens, a speed
range will be indicated on
the speedometer:
The higher speed (the cur-
rently set speed (5)) will be
marked in green.
The lower speed in the range is the speed of
the vehicle ahead.
Related information
•
Adaptive Cruise Control – introduction
(p. 184)
Changing the set speed
•
Controls and display
After a speed has been set, it can be
increased or decreased by briefly press-
Put in active mode and set a speed (each
additional press increases/decreases
speed by 1 mph (approximately 2 km/h))
ing the
or
buttons. Each time one
of these buttons is pressed, the vehicle's
speed changes by 5 mph or 5 km/h. If the
speed is increased by pressing the accel-
erator pedal, the vehicle's speed when
the button is pressed will be set.
•
Press
or
(4).
>
The set speed, for example 60 mph (5),
will be magnified for several seconds and
the frame around the speed will change
colors from white to green to indicate
that this speed has been stored (set).
07
Press and hold one of these buttons to
increase/decrease the speed in 1-mph or
1-km/h increments. Release the button
when you have reached the desired
speed.
•
When this symbol has changed col-
ors from white to green, ACC is in
active mode and the vehicle will
maintain the set speed.
188
English 
