FOX 2004 ➤
3 - Cyl. injection engine - Edition 12.2009
1.1
Fuel supply system components - remove and install
1 - Fastening clip
2 - Reservoir lid
3 - Sealing ring
❑ Replace if damaged.
4 - Fastening screw
5 - Fuel supply nozzle com‐
partment cover
❑ With rubber bellows.
❑ Remove and install⇒
Body - External assem‐
bly works; Rep. Gr. 55 ;
Hoods .
6 - Vent valve
7 - Gravity valve
❑ Remove rear right
wheel case protector.
❑ Remove the cover from
fuel tank nozzle com‐
partment with bellows.
❑ Check valve passage
continuity. Perpendicu‐
lar valve: open. Valve in‐
clined 45°: closed.
lk
8 - Fuel supply tube
9 - Spring clamp
10 - Fuel reservoir
❑ Remove using the En‐
gine / gearbox or VAG
1383A jack. -EQ 7081- .
❑ Remove and install
⇒ page 68 .
11 - 23...29 Nm
12 - Pipes
❑ Anti-choke for fuel tank up to expansion tank.
13 - Pipes
❑ Venting for fuel tank up to expansion tank.
14 - Bearing
15 - Expansion reservoir
16 - Pipes
❑ Anti-choke for the fuel tank supply nozzle housing.
17 - Pipes
❑ Venting for the fuel tank supply nozzle housing.
18 - Fuel pump (pre-supply pump) -G6-
❑ Remove and install ⇒ page 66 .
❑ Clean the filter, in case it is dirty.
❑ Fuel pump (pre-supply pump) -G6- - check ⇒ page 71 .
❑ Observe the flange installation position in the fuel tank ⇒ page 64
1. Fuel supply system components - remove and install
63
English 
