FOX 2004 ➤
3 - Cyl. injection engine - Edition 12.2009
The -arrows- shows the installation position of the Fuel pump (pre-
supply pump) flange -G6- .
Note
To remove fuel hoses, press the safety key located under the
connection.
– Remove the lock with Wrench -VW 5321/9- or Wrench -
T10334- .
– Remove the Fuel pump (pre-supply pump) -G6- and the seal
from the opening in the fuel tank.
Note
In case of replacing the Fuel pump (pre-supply pump) -G6- , emp‐
ty the old Fuel pump (pre-supply pump) -G6- before disposing it.
1.4.2
Installation
– Fuel pump (pre-supply pump) -G6- must be installed in the
reverse sequence to the removal.
lk
Note
♦ Try not to bend the Fuel level indicator sensor -G- during in‐
stallation.
♦ Install Fuel pump (pre-supply pump) -G6- sealing dry on fuel
tank opening.
♦ Lubricate the sealing with fuel only for installing the Fuel pump
(pre-supply pump) -G6- .
♦ Observe installation position of the Fuel pump (pre-supply
pump) -G6- -arrow-.
♦ The mark on the Fuel pump (pre-supply pump) -G6- shall
match that on the body.
♦ Check the firm seating of the fuel hoses.
♦ Do not confuse the supply and return hoses.
♦ After installation of the Fuel pump (pre-supply pump) -G6- ,
check whether the supply, return and vent pipes are still fas‐
tened to the fuel reservoir.
1.5
Fuel level sensor -G- - remove and in‐
stall
1.5.1
Removal
– Remove Fuel pump (pre-supply pump) -G6- ⇒ page 66 .
1. Fuel supply system components - remove and install
67
English 
