Get Crankshaft group -> 2.4 Renewing crankshaft oil seal, vibration damper end Guide for Volkswagen Touareg SUV First Generation (2002-2010)

Touareg 2003 ➤

8-cylinder injection engine - Edition 11.2011

– Pull oil seal with sealing flange -A- by the outside over sleeve

-T10122/1- onto pulling sleeve -T10122/2- .

– Separate the two fitting sleeves.

– Then set pulling sleeve -T10122/2- with dry seal and sealing

flange onto crankshaft journal.

– Bolt sealing flange to cylinder block. Specified torque: 10 Nm

– Install sump ⇒ page 70 .

– Install drive plate ⇒ page 22 .

– Install engine ⇒ page 3 .

2.4

Renewing crankshaft oil seal, vibration

damper end

Special tools and workshop equipment required

♦ Thrust piece -T40007-

♦ Torque wrench (150…800 Nm) -V.A.G 1601-

Removing

– Remove noise insulation tray.

– Remove toothed belt ⇒ page 34 .

– Unscrew centre bolt -2- from crankshaft toothed belt pulley

-1- and remove crankshaft toothed belt pulley from crankshaft

journal.

– Then remove seal using extractor hook -T20143/1- .

Rep. gr.13 - Crankshaft group

Touareg 2003 ➤

8-cylinder injection engine - Edition 11.2011

– Remove thrust washer from crankshaft journal and mark thrust

washer front face -arrow- using a waterproof felt-tip marker.

Installing

– Remove oil residue from crankshaft journal and thrust washer

using a clean cloth.

– Press new seal in to stop using thrust piece -T40007- .

– Reverse thrust washer and fit it on crankshaft journal with

marked front face towards engine.

– Install crankshaft toothed belt pulley using a new centre bolt.

Specified torque: 200 Nm + / turn (180°) further.

– Install toothed belt. ⇒ page 34

– Install poly V-belt ⇒ page 18 .

– Install noise insulation tray.

2. Removing and installing sealing flange and drive plate

Crankshaft group -> 2.4 Renewing crankshaft oil seal, vibration damper end for Your Volkswagen Touareg SUV First Generation (2002-2010)