Electrically closing the boot lid
1. Briefly press the
button on the open boot lid→ Fig. 1.
Or: grab the loop on the boot lid and pull it gently.
Acoustic warnings are given during closing.
Or: Pull the boot lid briefly by the handle.
Or: In vehicles with the keyless locking and starting system Keyless Access:Press and hold the
the vehicle key. The vehicle key must be in the operating range of the boot lid.
button on
The boot lid closes automatically.
The boot lid is also locked by the central locking system.
Interrupting the opening or closing procedure
If the boot lid is blocked by an obstacle, the opening and closing procedure will be interrupted immediately→
Opening and closing of the boot lid can be interrupted by pressing one of the buttons during the procedure.
.
1. Press and hold the
Or: Press the
button in the vehicle key to stop the procedure.
button in the open boot lid→ Fig. 1.
Or: Pull up and hold the
button in the driver door→ Fig. 2.
2. Move the boot lid by hand. You will need to use increased force to do this.
Pressing the
button again moves the boot lid back into the starting position.
Acoustic signals
Acoustic signals are given during the whole boot lid opening and closing procedure. Exception: If the boot lid is
operated via the handle or the button → Fig. 1.
Adjusting the opening angle
If the area behind or above the vehicle is smaller than the path of the boot lid, the opening angle can be changed, e.g.
in a garage.
The boot lid must be at least half open in order to store a new opening angle.
1. Stop the opening procedure at the desired position.
2. Press the
button in the open boot lid for at least three seconds.
The changed opening angle will be stored.
The hazard warning lights flash and an acoustic signal sounds to confirm that the changed opening angle has been
stored.
Resetting the opening angle
The opening angle will have to be reset and stored again in order to fully open the boot lid again.
1. Open the boot lid automatically up to the stored height.
117