Advertisement

Advertisement

Opening and closing -> Opening and closing the sliding window for Your Volkswagen Transporter Van Seventh Generation (2021-2025)

Opening and closing the sliding window  
Opening the sliding window in the sliding door  
1. Press the window buttons.  
The sliding window automatically springs inwards.  
2. Keep the window buttons in this position and open the sliding window.  
3. Release the window buttons.  
Closing the sliding window in the sliding door  
1. Press the window buttons.  
2. Keep the window buttons in this position and close the sliding window.  
3. Release the window buttons.  
When opening or closing, there are latching positions at various points in which the sliding window can be locked.  
From there, the window buttons must be pressed again to move further.  
WARNING  
In the event of a sudden braking manoeuvre or accident, a sliding window that is not securely engaged could move  
forward and cause injuries.  
Always engage the sliding windows securely.  
125  
Troubleshooting  
One-touch opening and closing is not working  
One-touch opening and closing is deactivated if the 12-volt vehicle battery has been disconnected or discharged  
while the windows were not fully closed. The function will have to be reset.  
1. Switch on the ignition.  
2. Close all windows and doors.  
3. Pull and hold the button for the respective window for a few seconds.  
4. Release the button.  
5. Pull and hold the button again.  
One-touch opening and closing is now ready for operation again.  
The one-touch function can be restored for individual windows or for several windows at the same time.  
The windows do not close  
1. Check if there is an obstacle in the operating area.  
2. Attempt to close the window again within a few seconds by pulling and holding the button.  
The roll-back function will be deactivated for a small section of the path of the closing window. If the closing  
procedure takes longer than several seconds, the roll-back function will be reactivated.  
If it is still stiff or obstructed, the window will stop and open again automatically.  
1. If the fault persists, the system should be checked by a correspondingly qualified workshop.  
126