2020-2024 Cupra Formentor SUV Driving -> Electrically unlocking trailer hook User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Electrically unlocking trailer hook for Your Cupra Formentor SUV First Generation (2020-2024)

Driving  
The trailer is connected to the towing vehi-  
cle through the trailer power socket.  
The stability system does not always de-  
Electrically unlocking trail-  
er hook  
tect light trailers, so it may not stabilise  
these correctly.  
The vehicle is travelling at over 60 km/h  
(approx. 37 mph).  
When driving on surfaces with poor grip,  
Description  
the trailer can even interfere with the sta-  
The maximum vertical load technically  
bility system.  
permissible is not being exceeded on the  
coupling device.  
Trailers with a high centre of gravity can  
tip over without having previously weaved.  
The trailer has a rigid draw bar.  
If a trailer is not attached, but a connec-  
If the trailer has brakes, it must be equip-  
tor is plugged into the power socket (e.g.  
installation of a bicycle rack with lights), re-  
peated automatic braking may occur in ex-  
treme driving conditions.  
ped with a mechanical overrun brake.  
WARNING  
The enhanced safety provided by the elec-  
tric stability control of the vehicle and trail-  
er should not lead you to take any risks that  
could compromise your safety.  
Fig. 188 On the left side of the luggage  
compartment: button for unlocking the  
tow hook.  
Adapt your speed and driving style at all  
times to suit visibility, weather, road and  
traffic conditions.  
The towing bracket’s hook is located in the  
bumper. Tow hooks for electrical unlocking  
cannot be removed.  
Accelerate with caution when the road is  
slippery.  
When adjusting any settings, stop accel-  
There should be no person, animal or object  
erating.  
in the path of the tow hook  
.
›››  
WARNING  
Unlocking the tow hook and removing it  
The electric stability control for the vehicle  
and trailer may not correctly detect all driv-  
ing conditions.  
Stop the vehicle and connect the electron-  
ic parking brake page 266 .  
›››  
Switch off the engine.  
Open the rear lid.  
When the ESC is switched off, the stabili-  
sation of the towing vehicle and trailer is al-  
so switched off.  
298  
Towing bracket device  
Pull the Fig. 188 button briefly. The tow  
tow hook has not been attached properly or  
›››  
If the ball has a diameter of less than 49  
hook unlocks electrically and automatically  
turns outwards. The button's control lamp  
flashes.  
is damaged  
.
›››  
mm at any one point, do not use the towing  
bracket under any circumstances.  
If the warning lamp Fig. 188 remains  
›››  
on with the rear lid open, the tow hook is  
correctly in place both when extracted and  
when covered.  
Finish remove the tow hook by hand until  
CAUTION  
you feel and hear that it has engaged and the  
control lamp on the button stays on.  
If you clean the vehicle with high-pressure  
or steam devices, do not point the jet di-  
rectly towards the retractable tow hook or  
the trailer power socket, as this may dam-  
age the joints or remove the grease neces-  
sary for lubrication.  
The control light of the lamp switches off ap-  
proximately 1 minute after closing the read  
lid.  
Close the rear lid.  
Hitching and connecting a trailer  
page 294.  
›››  
WARNING  
Retracting the tow hook  
Undue use of the towing bracket may cause  
injury and accidents.  
Note  
Stop the vehicle and apply the electronic  
parking brake.  
At extremely low temperatures, the tow  
hook may be impossible to operate. In this  
case, place the vehicle in a warmer location  
(for example, a garage).  
Only use the tow hook if it is properly en-  
gaged.  
Switch off the engine.  
Always ensure that no person, animal or  
Unhook the trailer and interrupt the elec-  
object is to be found in the path of the tow  
hook.  
trical connection between it and the vehicle.  
If you are using an adapter, remove it from  
the trailer's power socket.  
Never use a tool or instrument while the  
Fitting a bicycle carrier on the re-  
tractable towbar  
tow hook is moving.  
Open the rear lid.  
Never press the Fig. 188 button when  
›››  
Pull the Fig. 188 button briefly. The tow  
›››  
there is a trailer hooked to the vehicle or  
when a carrier system or other accessories  
are mounted on the tow hook.  
hook unlocks electrically.  
The maximum allowed weight of the carrier  
system, including the load, is 75 kg. The car-  
rier system should not protrude more than  
700 mm backwards from the spherical head.  
Only carrier systems on which up to 3 bikes  
can be mounted are allowed. Heavier bicy-  
cles must be mounted as close to the vehicle  
as possible (tow hook).  
Turn the tow hook under the bumper with  
your hand until you feel and hear that it en-  
gages and the control lamp on the button re-  
mains on continuously.  
If the tow hook is not attached properly,  
do not use it. Instead, go to a specialised  
workshop and have the towing bracket  
checked.  
Close the rear lid.  
If you detect any fault in the electrical  
»
system or in the towing bracket, contact a  
specialised workshop and ask them to  
check it.  
The control lamp   
If the warning light on the button  
Fig. 188 flashes, this means that the  
›››  
299  

Related Topics

Popular Owner Manuals