2020-2024 Cupra Formentor SUV Driving -> Speed limiter User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Speed limiter for Your Cupra Formentor SUV First Generation (2020-2024)

Driving  
Switching off  
A brake assistance system has intervened,  
Status display  
e.g. TCS or ESC.  
Press and hold the button .  
When the speed limiter is switched on, the  
instrument cluster display shows the saved  
speed and the system status:  
Front Assist has braked the vehicle.  
The cruise control system switches off and  
the saved speed is deleted.  
If the fault continues, disconnect the  
Emergency Assist and consult a specialised  
workshop.  
It lights up grey  
Switching off the speed limiter  
The speed limiter is switched on but regulation is not  
active.  
Press the button.  
Select the speed limiter on the instrument  
Speed limiter  
cluster display.  
It lights up green  
The cruise control system is switched off.  
Introduction  
The speed limiter is switched on and active.  
The speed limited helps the driver not to ex-  
ceed a set speed.  
Driving down slopes  
Problems and solutions  
Shift into a low gear before descending a  
long hill. This makes use of engine braking  
and relieves the brakes.  
Speed range  
Temporarily switching off the cruise  
control  
The speed limiter helps avoid exceeding a  
programmed speed, from 30 km/h (20 mph)  
approx. and faster.  
WARNING  
The control lamp switches on yellow.  
After use, always switch off the speed limit-  
er to prevent the speed being regulated  
against your wishes.  
Abnormal operation. Switch off the cruise  
control system and take the vehicle to a spe-  
cialist workshop.  
By selecting the speed limiter  
The speed limitation can be interrupted at  
any time by depressing the accelerator pedal  
fully, beyond the point of resistance. As soon  
as the saved speed is exceeded, the green  
indicator light flashes and an audible warning  
signal sounds. The speed is stored.  
The speed limiter does not relieve the  
driver of their responsibility to drive at the  
appropriate speed. Do not drive at high  
speed if not necessary.  
The adjustment is interrupted unexpect-  
edly  
If the clutch pedal is pressed for a long  
time.  
Using the speed limiter under adverse  
weather conditions is dangerous and can  
cause serious accidents, e.g. aquaplaning,  
snow, ice, leaves, etc. Only use the speed  
limiter when the status of the road and the  
weather conditions allow it.  
The vehicle has exceeded the saved speed  
for a long time.  
The limiter is reactivated automatically after  
returning to less than the set speed.  
No forward gear has been selected.  
238  
Driver assistance systems  
- 10 km/h (5 mph)  
The control lamp switches on yellow.  
Operating the speed limiter  
Malfunctions Switch off the speed limiter  
Interrupting the adjustment  
and go to a specialist workshop.  
Press the button.  
The adjustment is interrupted unexpect-  
edly  
The speed is stored.  
You have switched off the Electronic Stabi-  
lization Control (ESC).  
Reinstating the cruise control  
Press the  button.  
The brakes have overheated. Wait for the  
The limiter will re-activate as soon as the ve-  
hicle is moving at a speed lower than the  
saved one.  
brakes to cool down and check the opera-  
tion again.  
Fig. 155 On the multifunction steering  
wheel: buttons to operate the speed limit-  
er.  
If the fault continues, consult a specialised  
workshop.  
Switching off  
For safety reasons, the speed limiter only  
switches off fully whenever the driver stops  
pressing the accelerator pedal or switches  
the system off manually.  
Press and hold the button .  
Connecting  
The speed limiter switches off and the speed  
is deleted.  
Press the button.  
It does not take effect yet.  
Switch to cruise control (GRA) or adaptive  
cruise control (ACC)  
Not possible to start regulation  
Start regulation  
The selected driving profile does not allow  
When the vehicle is moving, press the but-  
Press the button.  
regulation to start. Select another profile and  
repeat the procedure.  
ton .  
Observe the corresponding message on  
the instrument cluster display.  
The current speed is saved as a limit speed.  
The speed limiter is switched off.  
Adjusting the speed  
The programmed speed can be set:  
Problems and solutions  
 + 1 km/h (1 mph)  
 - 1 km/h (1 mph)  
The speed limiter is not active.  
+ 10 km/h (5 mph)  
239  

Related Topics

Popular Owner Manuals