2009-2015 Honda Jazz 4 Door Maintenance -> Changing the Oil and Filter User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Maintenance -> Changing the Oil and Filter for Your Honda Jazz 4 Door Second Generation (2009-2015)

07/09/12 09:47:48 32SAA650_290  
Engine Oil  
Additives  
Changing the Oil and Filter  
Your vehicle does not need any oil  
additives. Purchasing additives for  
the engine or transmission will not  
increase your vehicle’s performance  
or longevity. It only increases the  
cost of operating your vehicle.  
Always change the oil and filter  
according to the time and distance  
(kilometers/miles) recommenda-  
tions in the maintenance schedule.  
The oil and filter collect contami-  
nants that can damage your engine if  
they are not removed regularly.  
Repeated, prolonged  
exposure to used motor oil  
may cause skin cancer.  
Wash your hands thoroughly  
with strong soap as soon as  
possible after handling used  
oil.  
Changing the oil and filter requires  
special tools and access from  
underneath the vehicle. The vehicle  
should be raised on a service station-  
type hydraulic lift for this service.  
Unless you have the knowledge and  
proper equipment, you should have  
this maintenance done by a skilled  
technician.  
CONTINUED  
287  
Maintenance  
Downloaded from engine  
07/09/12 09:47:56 32SAA650_291  
Engine Oil  
1. Run the engine until it reaches  
normal operating temperature,  
then shut it off.  
The oil, engine components  
and the exhaust system are  
hot and can burn you.  
Use caution and wear  
protective clothing while  
working in the engine  
compartment.  
WASHER  
OIL DRAIN BOLT  
OIL FILTER  
2. Open the bonnet and remove the  
engine oil fill cap. Remove the oil  
drain bolt and washer from the  
bottom of the engine. Drain the oil  
into an appropriate container.  
3. Remove the oil filter and let the  
remaining oil drain. A special  
wrench is required to remove the  
filter.  
4. Check the oil filter to make sure  
its gasket did not stick to the  
engine block. A stuck gasket could  
cause an oil leak.  
5. Install a new oil filter according to  
instructions that come with it.  
288  
Maintenance  
Downloaded from engine  
07/09/12 09:48:03 32SAA650_292  
Engine Oil  
6. Put a new washer on the drain bolt, 8. Replace the engine oil fill cap.  
10.Turn off the engine, let it sit for  
approximately 3 minutes, then  
check the oil level. If necessary,  
add oil to bring the level to the  
upper mark on the dipstick.  
then reinstall the drain bolt.  
Tighten it to:  
Start the engine. The oil pressure  
indicator light should go out within  
five seconds. If it does not, turn off  
the engine and reinspect your  
work.  
39 N·m (4.0 kgf·m , 29 lbf·ft)  
7. Refill the engine with the recom-  
mended oil.  
9. Run the engine until warmed up,  
then check the drain bolt and oil  
filter for leaks.  
Engine oil change capacity  
(including filter):  
Improper disposal of engine oil can  
be harmful to the environment. If  
you change your own oil, please  
dispose of the used oil properly. Put  
it in a sealed container and take it to  
a recycling centre. Do not discard it  
in a waste bin or dump it on the  
ground.  
3.6 (3.8 US qt , 3.2 Imp qt)  
289  
Maintenance  
Downloaded from engine  

Related Topics

Popular Owner Manuals