2009-2015 Honda Jazz 4 Door Maintenance -> Wiper Blades User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Maintenance -> Wiper Blades for Your Honda Jazz 4 Door Second Generation (2009-2015)

07/09/12 09:51:30 32SAA650_317  
Wiper Blades  
Check the condition of the wiper  
blades at least every six months.  
Look for signs of cracking in the  
rubber, or areas that are getting  
hard. Replace the blades if you find  
these signs, or if they leave streaks  
and unwiped areas when used.  
WIPER ARMS  
LOCK TAB  
To replace the front wiper blades:  
1. Raise the wiper arm off the  
windscreen.  
Raise the driver’s side first, then  
the passenger’s side.  
2. Disconnect the blade assembly  
from the wiper arm by pushing in  
the lock tab. Hold the lock tab in  
while you push the blade assembly  
toward the base of the arm.  
Do not open the bonnet when the  
wiper arms are raised, or you will  
damage the bonnet and the arms.  
314  
Maintenance  
Downloaded from engine  
07/09/12 09:51:38 32SAA650_318  
Wiper Blades  
5. Slide the new wiper blade into the  
holder fully.  
BLADE  
BLADE  
6. Slide the wiper blade assembly  
onto the wiper arm. Make sure it  
locks in place.  
7. Lower the wiper arm down against  
the windscreen.  
Lower the passenger’s side first,  
then the driver’s side.  
REINFORCEMENT  
3. Remove the blade from its holder  
by grasping the closed end of the  
blade. Pull firmly until the open  
end comes out of the holder.  
4. Examine the new wiper blades. If  
they have no plastic or metal rein-  
forcement along the back edge,  
remove the metal reinforcement  
strips from the old wiper blade and  
install them in the slots along the  
edge of the new blade.  
315  
Maintenance  
Downloaded from engine  
07/09/12 09:51:47 32SAA650_319  
Wiper Blades  
BLADE  
REINFORCEMENT  
To replace the rear wiper blade:  
4. Examine the new wiper blade. If it  
has no plastic or metal rein-  
6. Insert both ends of the blade into  
the holder. Make sure they are  
secure.  
1. Raise the wiper arm off the  
windscreen.  
forcement along the back edge,  
remove the metal reinforcement  
strips from the old wiper blade and 7. Lower the wiper arm.  
install them in the slots along the  
edge of the new blade.  
2. Pull one end of the blade out from  
the holder.  
3. Slide the blade out of the holder.  
5. Slide the new blade into the holder.  
Make sure it is engaged in the slot  
along its full length.  
316  
Maintenance  
Downloaded from engine  

Related Topics

Popular Owner Manuals