Get FEATURES OF YOUR HYUNDAI -> SEATS Guide for Hyundai Tucson SUV First Generation (2004-2009)

FEATURES OF YOUR HYUNDAI

SEATS

B080A01A-AAT

ADJUSTABLE SEATS

WARNING:

Never attempt to adjust the seat

while the vehicle is moving. This

could result in loss of control or an

accident which may cause death,

serious injury, or property damage.

B080B02FC-AAT

FRONT SEATS

Adjusting Seat Forward and

Rearward

To move the seat toward the front or

rear, pull the lock release lever up-

ward. This will release the seat on its

track so you can move it forward or

rearward to the desired position. When

you find the position you want, release

the lever and slide the seat forward or

rearward on its track until it locks into

the desired position and cannot be

moved further.

OJM019001

WARNING:

1) Be careful that someone's head,

hands and body are not trapped

by a closing window.

2) Never try to operate the main

switch on the driver's door and

the individual door window

switch in opposing directions at

the same time. If this is done, the

window will stop and cannot be

opened or closed.

3) Do not leave children alone in the

car. Always remove the ignition

key for their safety.

HJM2016

ated without the ignition key turned

to the "ON" position.

Open

FEATURES OF YOUR HYUNDAI

WARNING:

To minimize risk of severe injury in

the event of a collision or a sudden

stop, both the driver and passen-

ger seatbacks should always be in

an upright position while the ve-

hicle is in motion. The protection

provided by the seat belts and

airbags in a frontal collision may be

reduced significantly when the

seatbacks are reclined. There is

greater risk that the driver and pas-

senger will slide under the seat belt

which may result in serious injury if

a crash occurs when the seatbacks

are reclined. The seat belt and

airbags cannot provide proper pro-

tection to an occupant if the seat

back is reclined.

To recline the seatback, lean forward to

take your weight off it, then pull up on

the recliner control lever at the outside

edge of the seat. Now lean back until

the desired seatback angle is achieved.

To lock the seatback into position,

release the recliner control lever.

OJM019002

B080C02A-AAT

Adjusting Seatback Angle

WARNING:

To ensure the seat is locked se-

curely, attempt to move the seat

forward or rearward without using

the lock release lever.

FEATURES OF YOUR HYUNDAI

C010104BUN

Headrest

OJM069015

WARNING:

o For maximum effectiveness in case

of an accident, the headrest should

be adjusted so the middle of the

headrest is at the same height of

the center of gravity of an

occupant's head. Generally, the

center of gravity of most people's

head is similar with the height of

the top of their eyes. Also, adjust

the headrest as close to your head

as possible. For this reason, the

use of a cushion that holds the

body away from the seatback is

not recommended.

o Do not operate the vehicle with the

headrests removed as severe in-

jury to the occupants may occur in

the event of an accident. Head-

rests may provide protection

against neck injuries when prop-

erly adjusted.

o Do not adjust the headrest posi-

tion of the driver’s seat while the

vehicle is in motion.

The driver's and front passenger's seats

are equipped with a headrest for the

occupant's safety and comfort.

The headrest not only provides comfort

for the driver and front passenger, but

also helps to protect the head and neck

in the event of a collision.

HJM2045-2

Forward and backward adjust-

ment (if installed)

The headrest may be adjusted forward

to 3 different positions by pulling the

headrest forward to the desired detent.

To adjust the headrest to it’s furthest

backwards position, pull it fully forward

to the farthest position and release it.

Adjust the headrest so that it properly

supports the head and neck.

FEATURES OF YOUR HYUNDAI

B080F02S-AAT

Seat Cushion Height Adjustment

(Driver's Seat Only)

To change the height of the seat cush-

ion, rotate the knob located on the

outside of the seat cushion.

OJM019003

Adjusting the height up and

down

To raise the headrest, pull it up to the

desired position (1). To lower the head-

rest, push and hold the release button

(2) on the headrest support and lower

the headrest to the desired position (3).

OJM069016

Removal

To remove the headrest, raise it as far

as it can go then press the release

button (1) while pulling upward (2).

To reinstall the headrest, put the head-

rest poles (3) into the holes while press-

ing the release button (1). Then adjust

it to the appropriate height.

OJM069017

WARNING:

Make sure the headrest locks in po-

sition after adjusting it to properly

protect the occupants.

FEATURES OF YOUR HYUNDAI

B100A02JM-GAT

SEAT WARMER (If installed)

The seat warmer is provided to warm

the front seats during cold weather.

With the ignition key in the "ON" posi-

tion, push either of the switches to

warm the driver's seat or the

passenger's seat.

During mild weather or under conditions

where the operation of the seat warmer

is not needed, keep the switches in the

"OFF" position.

OJM019031

B080E02Y-AAT

Lumbar Support Control

(Driver's seat only) (If installed)

To adjust the lumbar support, turn the

handle on the outboard side of the seat.

To increase the amount of lumbar sup-

port, pull the lever forward. To decrease

it, push the lever toward the rear.

1. Minimum support

2. Maximum support

OJM019004

NOTE:

o The seat warmer will not operate

if the ambient temperature is

higher than 28°C ± 3.5°C.

o If the seat warmer doesn't work

when ambient temperature is

lower than 24°C, it should be

checked at an authorized dealer.

WARNING:

It is recommended that the seat

heater not be used when elderly

people or people who are ill occupy

the seat. Also, do not use the seat

warmer if the occupant is sleeping.

FEATURES OF YOUR HYUNDAI

NOTE:

o Before folding the seatback, place

the rear seat belt buckles in the

buckle pouch on the seatback.

This will prevent the seat belt

buckles from becoming covered

by the seat cushion when it is

returned to the seating position.

OJM019060

CAUTION:

Be careful to load the luggage on

the folded seatback. It may cause

damage seatback.

B085A01JM-GAT

REAR SEAT

Adjusting Seatback Angle

To recline the seatback, pull the

seatback folding lever and release it

after the desired seatback angle is

achieved.

When you recline the seatback to de-

sired position, always be sure it has

locked into position.

OJM019006

Seatback

folding lever

CAUTION:

When reclining the seatback, you

should adjust the seatback folding

lever while standing.

OJM019005

B085B02JM-AAT

Folding Rear Seatback

For convenience, the seatbacks and

seat cushions may be folded down and

up.

1. Pull the seatback folding lever then

push down the seatback.

2. Be sure it has locked into position to

listen an audible "Click".

FEATURES OF YOUR HYUNDAI

WARNING:

o The purpose of the fold-down

rear seat back is to allow you to

carry more objects than could

otherwise be accommodated.

Never allow passengers to sit on

the cargo area while the car is

moving. This is not a proper seat-

ing position and no seat belts are

available for use when the seat

back is folded down.

3. To return the seatback to its normal

position, pull the seatback folding

lever and reverse the above proce-

dure.

o When you return the seatback to its

upright position, always be sure it is

locked into position by pulling and

pushing on the top of the seatback.

This could result in serious injury

or death in case of an accident or

a sudden stop. Objects should not

extend higher than the top of the

front seatbacks.

This could allow cargo to slide

forward and cause injury or dam-

age during sudden stops.

o When you return the rear

seatback to its upright position

after being folded down, be care-

ful not to damage the seatbelt

webbing or buckle. In addition,

do not allow the seatbelt web-

bing or buckle to get caught or

pinched in the rear seat.

o When you return the rear

seatback to its upright position,

be sure it is locked into position

to attempt move it.

o Never attempt to fold or return

seat while the vehicle is moving.

C010303BPA

Headrest

OJM069015R

The rear seat(s) is equipped with head-

rests in all the seating positions for the

occupant's safety and comfort.

The headrest not only provides comfort

for passengers, but also helps to pro-

tect the head and neck in the event of

a collision.

FEATURES OF YOUR HYUNDAI

WARNING:

o For maximum effectiveness in case

of an accident, the headrest should

be adjusted so the middle of the

headrest is at the same height of

the center of gravity of an

occupant's head. Generally, the

center of gravity of most people's

head is similar with the height of

the top of their eyes. Also adjust

the headrest as close to your head

as possible. The use of a cushion

that holds the body away from the

seatback is not recommended.

o Do not operate the vehicle with the

headrests removed as severe in-

jury to an occupant may occur in

the event of an accident. Head-

rests may provide protection

against severe neck injuries when

properly adjusted.

OJM069016R

Adjusting the height up and

down

To raise the headrest, pull it up to the

highest position (1). To lower the head-

rest, push and hold the release button

(2) on the headrest support and lower

the headrest to the lowest position (3).

Removal

To remove the headrest, raise it as far

as it can go then press the release

button (1) while pulling upward (2).

To reinstall the headrest, put the head-

rest poles (3) into the holes while press-

ing the release button (1). Then adjust

it to the appropriate height.

OJM069017R

WARNING:

Make sure the headrest locks in po-

sition after adjusting it to properly

protects the occupants.

FEATURES OF YOUR HYUNDAI -> SEATS for Your Hyundai Tucson SUV First Generation (2004-2009)

Related Topics

Popular Owner Manuals

Latest Owner Manuals