2010-2019 Nissan Juke SUV Maintenance and do-it-yourself -> General maintenance User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Maintenance and do-it-yourself -> General maintenance for Your Nissan Juke SUV First Generation (2010-2019)

MAINTENANCE REQUIREMENTS  
GENERAL MAINTENANCE  
During normal day-to-day operation of the vehicle,  
general maintenance should be performed regularly as  
prescribed in this section. If you detect any unusual  
sounds, vibrations or smells, be sure to check for the  
cause or have a NISSAN dealer do it promptly. In  
addition, you should notify a NISSAN dealer if you think  
that repairs are required.  
WHERE TO GO FOR SERVICE  
Some day-to-day and regular maintenance is essential  
to maintain your vehicle’s good mechanical condition,  
as well as its emission and engine performance.  
If maintenance service is required or your vehicle  
appears to malfunction, have the systems checked and  
tuned by an authorized NISSAN dealer.  
It is the owner’s responsibility to make sure that the  
specified maintenance, as well as general mainte-  
nance, is performed.  
As the vehicle owner, you are the only one who can  
ensure that your vehicle receives the proper main-  
tenance care.  
When performing any checks or maintenance work,  
closely observe “Maintenance precautions” (P.8-4).  
EXPLANATION OF GENERAL MAINTE-  
NANCE ITEMS  
Additional information on the following items  
with *is found later in this section.  
SCHEDULED MAINTENANCE  
For your convenience, the required scheduled main-  
tenance items are described and listed in a separate  
Warranty Information and Maintenance booklet. You  
must refer to that booklet to ensure that necessary  
maintenance is performed on your vehicle at regular  
intervals.  
Outside vehicle  
The maintenance items listed here should be per-  
formed from time to time, unless otherwise specified.  
GENERAL MAINTENANCE  
Doors and hood:  
General maintenance includes those items which  
should be checked during normal day-to-day operation  
of the vehicle. They are essential if your vehicle is to  
continue to operate properly. It is your responsibility to  
perform these procedures regularly as prescribed.  
Check that all doors and the hood operate smoothly as  
well as the back door, trunk lid and hatch. Also make  
sure that all latches lock securely. Lubricate if  
necessary. Make sure that the secondary latch keeps  
the hood from opening when the primary latch is  
released. When driving in areas using road salt or  
other corrosive materials, check lubrication frequently.  
Performing general maintenance checks requires  
minimal mechanical skill and only  
automotive tools.  
a
few general  
Lights*:  
These checks or inspections can be done by yourself,  
a qualified technician, or if you prefer, your NISSAN  
dealer.  
Clean the headlights on a regular basis. Make sure that  
the headlights, stop lights, tail lights, turn signal lights,  
and other lights are all operating properly and installed  
securely. Also check the aim of the headlights.  
8-2 Maintenance and do-it-yourself  
Tires*:  
needed.  
Steering wheel:  
Check the pressure with a gauge often and always  
prior to long distance trips. Adjust the pressure in all  
tires, including the spare, to the pressure specified.  
Check carefully for damage, cuts or excessive wear.  
Check for changes in the steering condition, such as  
excessive play, hard steering or strange noises.  
Windshield:  
Clean the windshield on a regular basis. Check the  
windshield at least every six months for cracks or other  
damage. Repair as necessary.  
Warning lights and chimes:  
Make sure that all warning lights and chimes are  
operating properly.  
Tire rotation*:  
Wiper blades*:  
In the case that Two-Wheel Drive (2WD) and front &  
rear tires are same size; Tires should be rotated every  
10,000 km (6,000 miles). Tires marked with directional  
indicators can only be rotated between front and rear.  
Make sure that the directional indicators point in the  
direction of wheel rotation after the tire rotation is  
completed.  
Check for cracks or wear if not functioning correctly.  
Replace as necessary.  
Windshield defogger:  
Check that the air comes out of the defogger outlets  
properly and in good quantity when operating the  
heater or air conditioner.  
Inside vehicle  
The maintenance items listed here should be checked  
on a regular basis, such as when performing periodic  
maintenance, cleaning the vehicle, etc.  
Windshield wiper and washer*:  
Check that the wipers and washer operate properly  
and that the wipers do not streak.  
In the case that Four-Wheel Drive (4WD) and front &  
rear tires are same size; Tires should be rotated every  
5,000 km (3,000 miles). Tires marked with directional  
indicators can only be rotated between front and rear.  
Make sure that the directional indicators point in the  
direction of wheel rotation after the tire rotation is  
completed.  
Accelerator pedal:  
Under hood and vehicle  
Check the pedal for smooth operation and make sure  
that the pedal does not catch or require uneven effort.  
Keep the floor mats away from the pedal.  
The maintenance items listed here should be checked  
periodically (for example, each time you check the  
engine oil or refuel).  
Brake pedal*:  
Check the pedal for smooth operation and make sure  
that it is the proper distance from the floor mat when  
depressed fully. Check the brake booster function. Be  
sure to keep the floor mats away from the pedal.  
Battery*:  
In the case that front tires are different size from rear  
tires; Tires cannot be rotated.  
Except for maintenance free battery, check the fluid  
level in each cell. It should be between the “UPPER”  
and “LOWER” lines. Vehicles operated in high  
temperatures or under severe conditions require  
frequent checks of the battery fluid level.  
However, the timing for tire rotation may vary according  
to your driving habits and the road surface conditions.  
Parking brake*:  
Tire Pressure Monitoring System (TPMS) trans-  
mitter components (if equipped):  
Check the parking brake operation regularly. Check  
that the lever (if equipped) or the pedal (if equipped)  
has the proper travel. Also make sure that the vehicle is  
held securely on a fairly steep hill when only the  
parking brake is applied.  
Brake (and clutch) fluid level(s)*:  
Replace the TPMS transmitter grommet seal, valve  
core and cap when the tires are replaced due to wear  
or age.  
For Manual Transmission (MT) model; make sure that  
the brake and clutch fluid levels are between the  
“MAX” and “MIN” lines on the reservoirs.  
Seat belts:  
Wheel alignment and balance:  
Except for Manual Transmission (MT) model; make  
sure that the brake fluid level is between the “MAX”  
and “MIN” lines on the reservoir.  
Check that all parts of the seat belt system (for  
example, buckles, anchors, adjusters and retractors)  
operate properly and smoothly, and are installed  
securely. Check the belt webbing for cuts, fraying,  
wear or damage.  
If the vehicle should pull to either side while driving on  
a straight and level road, or if you detect uneven or  
abnormal tire wear, there may be a need for wheel  
alignment. If the steering wheel or seat vibrates at  
normal highway speeds, wheel balancing may be  
Maintenance and do-it-yourself 8-3  
Coolant level* :  
position (Manual Transmission models).  
.
Your vehicle is equipped with an automatic  
engine cooling fan. It may come on at any  
time without warning, even if the ignition  
switch is in the OFFposition and the  
engine is not running. To avoid injury, always  
disconnect the negative battery cable before  
working near the fan.  
Check the coolant level when the coolant is cold. Make  
sure that the coolant level is between the “MAX” and  
“MIN” lines on the reservoir.  
.
.
.
Be sure the ignition switch is in the OFFor  
LOCKposition when performing any parts  
replacement or repairs.  
Do not work under the hood while the  
engine is hot. Always turn off the engine  
and wait until it cools down.  
Engine drive belt(s)*:  
Make sure that drive belt(s) is/are not frayed, worn,  
cracked or oily.  
.
.
Always wear eye protection whenever you  
work on your vehicle.  
If you must work with the engine running,  
keep your hands, clothing, hair and tools  
away from moving fans, belts and any other  
moving parts.  
Engine oil level*:  
Never leave the engine or transmission  
related component harness connector dis-  
connected while the ignition switch is in the  
ONposition.  
Check the level after parking the vehicle (on a level  
ground) and turning off the engine.  
Fluid leaks:  
.
.
It is advisable to secure or remove any loose  
clothing and any jewelry, such as rings,  
watches, etc. before working on your vehi-  
cle.  
Check under the vehicle for fuel, oil, water or other fluid  
leaks after the vehicle has been parked for a while.  
Water dripping from the air conditioner after use is  
normal. If you should notice any leaks or if fuel fumes  
are evident, check for cause and have it corrected  
immediately.  
.
Avoid direct contact with used engine oil and  
coolant. Improperly disposed engine oil,  
engine coolant, and/or other vehicle fluids  
can hurt the environment. Always conform to  
local regulations for disposal of vehicle  
fluids.  
If you must run the engine in an enclosed  
space such as a garage, be sure there is  
proper ventilation for exhaust gases to  
escape.  
Windshield washer fluid*:  
This “8. Maintenance and do-it-yourself” section  
provides instructions regarding only those items which  
are relatively easy for an owner to perform.  
.
.
.
Never get under the vehicle while it is  
supported by a jack.  
Check that there is adequate fluid in the reservoir.  
MAINTENANCE PRECAUTIONS  
Keep smoking materials, flame and sparks  
away from fuel and the battery.  
You should be aware that incomplete or improper  
servicing may result in operating difficulties or ex-  
cessive emissions, and could affect your warranty  
coverage. If in doubt about any servicing, have it  
done by a NISSAN dealer.  
When performing any inspection or maintenance work  
on your vehicle, always take care to prevent serious  
accidental injury to yourself or damage to the vehicle.  
The following are general precautions which should be  
closely observed.  
Never connect or disconnect either the  
battery or any transistorized component  
connector while the ignition switch is in the  
ONposition.  
.
On gasoline engine models with the Multi-  
port Fuel Injection (MFI) system, the fuel  
filter and fuel lines should be serviced by a  
NISSAN dealer because the fuel lines are  
under high pressure even when the engine is  
turned off.  
WARNING:  
.
Park the vehicle on a level surface, apply the  
parking brake securely and block the wheels  
to prevent the vehicle from moving. Move  
the shift lever to the P(Park) position  
(Continuously Variable Transmission mod-  
els) or the shift lever to the N(Neutral)  
8-4 Maintenance and do-it-yourself  

Related Topics

Popular Owner Manuals