2010-2019 Nissan Juke SUV Maintenance and do-it-yourself -> Lights User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Maintenance and do-it-yourself -> Lights for Your Nissan Juke SUV First Generation (2010-2019)

LIGHTS  
Extended storage fuse switch (if equipped)  
HEADLIGHTS  
CAUTION:  
Fog may temporarily form inside the lens of the exterior  
lights in the rain or in a car wash. A temperature  
difference between the inside and the outside of the  
lens causes the fog. This is not a malfunction. If large  
High-pressure halogen gas is sealed inside the  
bulb. The bulb may break if the glass envelope is  
scratched or the bulb is dropped.  
drops of water collect inside the lens, contact  
NISSAN dealer.  
a
Xenon headlight models  
If replacement is required, contact a NISSAN dealer.  
WARNING:  
SDI2705  
HIGH VOLTAGE  
If any electrical equipment does not operate, remove  
the extended storage fuse switch and check for an  
open fuse.  
When xenon headlights are on, they produce a  
high voltage. To prevent an electric shock, never  
attempt to modify or disassemble. Always have  
your xenon headlights replaced at a NISSAN  
dealer.  
NOTE:  
If the extended storage fuse switch malfunc-  
tions, or if the fuse is open, it is not necessary to  
replace the switch. In this case, remove the  
extended storage fuse switch and replace it with  
a new fuse of the same rating.  
Use the same number and wattage as originally  
installed:  
Low beams (Xenon)  
Wattage: 35  
Bulb no.: D2S  
How to remove the extended storage fuse  
switch:  
High beams (Xenon)  
Wattage: 60  
Bulb no.: HB3  
1. To remove the extended storage fuse switch, be  
sure the ignition switch is in the “OFF” or “LOCK”  
position.  
2. Be sure the headlight switch is in the “OFF”  
position.  
Halogen headlight models  
The halogen headlight is a semi-sealed beam type  
which uses replaceable headlight (halogen) bulbs.  
They can be replaced from inside the engine compart-  
ment without removing the headlight assembly.  
3. Remove the fuse box cover.  
4. Pinch the storage switch and pull it in the direction  
illustrated.  
8-20 Maintenance and do-it-yourself  
A
Left side of the vehicle:  
1. Remove tabs  
.
Right side of the vehicle:  
*
B
2. Pull up part  
of the air duct, and then move  
*
C
*
part  
sideways.  
D
3. Remove the air duct  
.
*
E
*
4. Remove back cover  
.
F
5. Disconnect electrical connector  
.
*
G
*
6. Turn and pull out socket  
bulb.  
, and then remove the  
JVM0488X  
JVM0489X  
Disconnect the battery negative cable before replacing  
bulbs.  
Disconnect the battery negative cable before replacing  
bulbs.  
Maintenance and do-it-yourself 8-21  
A
1. Remove clip  
.
*
EXTERIOR LIGHTS  
INTERIOR LIGHT  
B
2. Remove washer inlet  
3. Remove back cover  
.
*
Item  
Wattage (W)  
Item  
Wattage (W)  
C
*
.
Front turn signal light  
Front clearance light*  
Front fog light (if equipped)  
Side turn signal light*  
Rear combination lights  
21  
LED  
55  
Map light  
5
5
D
4. Disconnect electrical connector  
.
*
Cargo room light  
E
*
5. Turn and pull out socket  
bulb.  
, and then remove the  
LED  
CAUTION:  
Turn signal  
21  
21/5  
LED  
16  
.
.
When handling the bulb, do not touch the  
glass envelope.  
Stop/tail light  
Tail light (LED)*  
Reverse light  
Do not leave the bulb out of the headlight  
reflector for a long period of time as dust,  
moisture and smoke may enter the headlight  
body and affect the performance of the  
headlight.  
High-mounted stop light*  
License plate light  
LED  
5
Use the same number and wattage as originally  
installed:  
*:  
See a NISSAN dealer for replacement.  
Halogen headlight models  
High beam bulb: 60W (HB3)  
Low beam bulb: 55W (H11)  
Aiming adjustment is not necessary if only the bulbs  
are replaced. When aiming adjustment is necessary,  
contact a NISSAN dealer.  
8-22 Maintenance and do-it-yourself  
1.  
2.  
3.  
4.  
5.  
6.  
7.  
8.  
9.  
Map light  
LIGHT LOCATIONS  
Front fog light (if equipped)  
Headlight (high-beam/low-beam)  
Clearance light  
Front turn signal light  
Side turn signal light  
High-mounted stop light  
Reverse light  
Rear turn signal light  
10. Stop/tail light  
11. License plate light  
12. Cargo room light  
13. Tail light (LED)  
JVM0483X  
Maintenance and do-it-yourself 8-23  
Replacement procedures  
JVM0484X  
Front turn signal light  
SDI1805  
REMOVE  
:
:
INSTALL  
All other lights are either type A, B, C or D. When  
replacing a bulb, first remove the lens and/or cover.  
JVM0485X  
Front fog light (if equipped)  
8-24 Maintenance and do-it-yourself  
JVM0486X  
Rear combination light  
To replace the rear combination light bulbs:  
A
1. Remove the bolts  
combination light  
and move up the rear  
to make a clearance, then  
*
B
*
carefully pry the light using a suitable tool.  
2
3
2. Replace the bulbs. (  
Stop/tail light,  
Turn  
*
*
1
signal light,  
Reverse light)  
*
3. Install the combination light in the reverse order of  
removal.  
SDI2391  
SDI2653  
Map light  
Cargo room light  
JVM0487X  
License plate light  
Maintenance and do-it-yourself 8-25  

Related Topics

Popular Owner Manuals