13. Stop the engine and check coolant level, allow
to cool and refill up to the MAX level.
6. Install the hose and securely tighten the engine
block drain plug.
HR16DE, MR20DE, M9R or R9M
engine
14. Check radiator lower hose for any signs of leak-
age.
7. Fill the reservoir up to the MAX level with cool-
ant. See “Capacities and recommended
fuel/lubricants” in the “9. Technical information”
section for cooling system capacity.
1. Set the heater or air conditioner temperature
control to the maximum “HOT” position.
15. Close the bonnet.
2. Open the bonnet. For details, see “Bonnet
release” in the “3. Pre-driving checks and
adjustments” section.
8. Install the engine coolant reservoir cap.
9. Start the engine, and rev the engine two or three
times under no load.
3. Open the engine coolant reservoir cap j1 to
help to drain the coolant.
10. Touch the radiator hose and feel if the water
flows.
4. Disconnect the end of the hose j2 to drain the
coolant.
11. Keep racing the engine at a speed of 2,000 –
2,500 rpm for about 10 minutes.
5. Flush the cooling system by running clean water
through the engine coolant reservoir.
NDI941Z
12. Observe the coolant temperature gauge for
signs of overheating.
6. Install the hose j2 .
7. Fill the coolant reservoir up to the MAX level.
K9K engine
13. Stop the engine and check coolant level, allow
to cool and refill up to the MAX level.
See
“Capacities
and
recommended
fuel/lubricants” in the “9. Technical information”
section for cooling system capacity.
1. Set the heater or air conditioner temperature
control to the maximum “HOT” position.
14. Check the radiator lower hose for any signs of
leakage.
8. Install the engine coolant reservoir cap.
2. Open the bonnet. For details, see “Bonnet
release” in the “3. Pre-driving checks and
adjustments” section.
15. Close the bonnet.
9. Start the engine, and rev the engine two or three
times under no load.
3. Disconnect the radiator lower hose j1 and open
the drain plug j2 on the engine block.
10. Touch the radiator hose and feel if the water
flows.
4. Open the engine coolant reservoir cap to help to
drain the coolant.
11. Keep racing the engine at a speed of 3,000 rpm
for about 10 minutes.
5. Flush the cooling system by running fresh water
through the engine coolant reservoir.
12. Observe the coolant temperature gauge for
signs of overheating.
Maintenance and do-it-yourself 8-7
Downloaded from manuals search engine