7. After the engine has been warmed up, make sure
there are no leaks around the engine oil filter unit
and the drain plug. Correct as required.
5. Wipe the oil filter cover entirely with a clean rag.
M9R or R9M engine
Installation:
1. Clean and re-install the drain plug along with a
new washer. For tightening torque details, see
“Changing engine oil” earlier in this section.
8. Turn the engine off and wait several minutes.
Check the oil level and add engine oil, if neces-
sary.
2. Install the rubber O-ring, in its housing, on the
outside of the engine oil filter cover.
9. Install the engine compartment under cover.
10. Lower the vehicle carefully to the ground.
11. Close the bonnet.
3. Insert the new oil filter element into the engine oil
filter cover.
NDI981Z
4. Coat the rubber O-ring with clean engine oil.
M9R
5. Install the engine oil filter cover until a slight re-
sistance is felt, then tighten additionally 2/3 of a
turn.
Tightening torque:
25 N•m (2.6 kg-m, 18 ft-lb)
6. Add engine oil and check the oil level with the
engine oil dipstick. For details, see “Checking
engine oil level” earlier in this section and “Ca-
pacities and recommended fuel/lubricants” in the
“9. Technical information” section.
NDI1267
7. Install the engine oil filler cap.
8. Start the engine.
R9M
Removal:
9. After the engine has been warmed up, make sure
there are no leaks around the engine oil filter
cover and the drain plug. Correct as required.
1. Drain the engine oil. For details, see “Changing
engine oil” earlier in this section.
2. Loosen the engine oil filter cover with a wrench.
10. Turn the engine off and wait several minutes.
Check the oil level and add engine oil, if neces-
sary.
3. Remove the engine oil filter cover then the oil fil-
ter element.
4. Remove the rubber O-ring from the filter cover.
11. Install the engine compartment undercover.
8-12 Maintenance and do-it-yourself
Downloaded from manuals search engine