2006-2014 Nissan Qashqai SUV Maintenance and do-it-yourself -> Fuses User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Maintenance and do-it-yourself -> Fuses for Your Nissan Qashqai SUV First Generation (2006-2014)

FUSES  
BACK DOOR WINDOW WIPER  
REPLACEMENT  
WINDSCREEN WASHER NOZZLE  
PASSENGER COMPARTMENT  
NDI892Z  
NDI924Z  
If you wax the surface of the engine bonnet, be care-  
ful not to let wax get into the washer nozzle jA . This  
may cause clogging or improper windscreen washer  
operation. If wax gets into the nozzle, remove it with  
a needle or small pin jB .  
1. Lift the wiper arm.  
2. Hold and rotate carefully the wiper blade clock-  
wise until the blade becomes free.  
3. Insert the new wiper blade onto the wiper arm  
and snap it into place.  
4. Return the wiper arm to its original position.  
NDI1088  
CAUTION  
Never use a fuse of higher or lower amperage  
rating than that specified on the fuse box  
cover.  
•
Never pull the harness or wires when discon-  
necting the connector.  
•
Maintenance and do-it-yourself 8-23  
Downloaded from manuals search engine  
Be careful not to damage the connector sup-  
port bracket when disconnecting the connec-  
tor.  
1. Make sure the ignition switch and the headlight  
switch are in the “OFF” position.  
•
ENGINE COMPARTMENT  
2. Open the bonnet. For details, see “Bonnet  
release” in the “3. Pre-driving checks and  
adjustments” section.  
If any electrical equipment does not operate, check  
for an open fuse.  
The fuse box is located in the lower part of the  
instrument panel at the driver’s side.  
3. Remove the clips j1 (where fitted) and air duct  
j2 (where fitted).  
The affected circuits j2 are shown on the back of  
the fuse box lid j1 .  
4. Remove the fusible link covers.  
5. Locate the fuse that needs to be replaced.  
1. Make sure the ignition switch and the headlight  
switch are in the “OFF” position.  
6. Remove the fuse with the fuse puller (where fit-  
ted). The fuse puller is located in the fuse box of  
the passenger compartment.  
2. Open the fuse box lid.  
3. Locate and remove the fuse with the fuse puller  
(where fitted).  
7. If the fuse is open jA , replace it with a new fuse  
jB .  
NOTE  
8. Install the fusible link covers.  
The fuse puller is stored in the fuse box.  
9. Install the air duct and clips (where fitted) in the  
reverse order of removal.  
4. If the fuse is open jA , replace it with a new fuse  
jB .  
10. Close the bonnet.  
5. Close the fuse box lid.  
NOTE  
NDI1089  
NOTE  
If the new fuse opens again, after installing,  
have the electrical system checked and re-  
paired by a NISSAN dealer or qualified work-  
shop.  
If the new fuse opens again, after installing,  
have the electrical system checked and re-  
paired by a NISSAN dealer or qualified work-  
shop.  
CAUTION  
Never use a fuse of higher or lower amperage  
rating than that specified on the fuse box cover.  
If any electrical equipment does not operate, check  
for an open fuse.  
8-24 Maintenance and do-it-yourself  
Downloaded from manuals search engine  

Related Topics

Popular Owner Manuals