Only hold the xenon headlight bulb by the
base.
3. When the broken bulb is located in the headlight
assembly under the air duct, carefully remove the
clips and rotate the air duct jc clockwise a 1/4
of a turn.
•
•
•
Replacing the halogen headlight bulb
CAUTION
The bulb is manufactured from high-quality
quartz and is under high pressure.
High pressure halogen gas is sealed inside
•
the halogen bulb. The bulb may break if the
glass envelope is scratched or the bulb is
dropped.
4. Remove the cap (jA or jB ) of the headlight as-
Damage, soiling, and fingerprints should be
avoided and, if necessary, removed with alco-
hol before installing the bulb.
sembly.
5. Turn the connector 1/4 of a turn in the anti clock-
wise direction and remove the headlight bulb.
When handling the bulb, DO NOT TOUCH THE
GLASS ENVELOPE.
•
When the headlights are switched on, the
bulbs produce a certain amount of UV radia-
tion. In order to avoid any impairment of health
(burning and conjunctivitis), the bulb should
only be used in closed headlights with appro-
priate UV–absorbing front glass.
•
6. Install the new bulb in the reverse order of re-
moval and make sure that the cap is securely
sealed with the headlight body.
Use the same number type and wattage as
originally installed.
•
Aiming is usually not necessary after replac-
•
7. Where removed (step 3.), re-install the air duct
ing the bulb. When aiming adjustment is nec-
essary, contact a NISSAN dealer or qualified
workshop.
jc and clips in the order of removal.
Due to the risk of burning, the bulb should be
left to cool down for 3 minutes after switching
off before touching.
•
•
•
•
8. Reconnect the negative (—) battery cable and
close the bonnet.
Do not leave the bulb out of the headlight
•
NOTE
reflector for a long period of time as dust,
moisture or smoke may enter the headlight
body and affect the performance of the head-
light.
Due to the use of mercury and various salts,
the bulb should be treated as special waste
when discarded.
Fog may temporarily form inside the lens of the
exterior lights in the rain or in a car wash. The fog
is caused by a temperature difference between
the inside and the outside of the lens. This is not
a malfunction. If large droplets can be seen, then
contact a NISSAN dealer or qualified workshop.
The bulb may only be operated with a suitable
ballast which produces very high voltages
when switched on and during operation.
The headlight is a semi-sealed beam type which
uses a replaceable headlight (halogen) bulb. A bulb
can be replaced from inside the engine compart-
ment without removing the headlight assembly.
Contact with bulb and wires should therefore
be avoided and a safe distance of at least 30
mm should be maintained.
Contact a NISSAN dealer or qualified workshop, if
you need assistance for bulb replacement.
1. Open the bonnet. For details, see “Bonnet
release” in the “3. Pre-driving checks and
adjustments” section.
2. Disconnect the negative (—) battery cable.
8-26 Maintenance and do-it-yourself
Downloaded from manuals search engine