HEADLIGHT BEAM ADJUSTMENT
Examples of positions for
adjusting
control A according to the load
Driver alone or with front passenger
0
1
All seats occupied
A
Driver with passengers and luggage
(or load) reaching the maximum
permissible all-up weight
Switch A is used to adjust the height of
the headlight beams according to the
load.
2
3
With the dipped beam headlights lit,
press or lift switch A as many times
as is necessary to select the required
position on the instrument panel. The
position selected is displayed on the
instrument panel for approximately
30 seconds.
Driver without passengers and luggage
(or load) reaching the maximum
permissible all-up weight
* depending on the vehicle
The table below gives some examples. In all cases, adjust control A accord-
ing to the vehicle load so that the road can be seen and other drivers are not
dazzled.
Note: lights on, at each engine start-
up the selected position is displayed on
the instrument panel for approximately
30 seconds.
If driving on the left in a left-hand drive vehicle (or vice versa), drivers must have
the lights adjusted by an authorised dealer for the duration of the trip.
1.105
English 
