Get Getting to know your vehicle -> Seat belts Guide for Renault Zoe 4 Door Third Generation (2019-2024)

SEAT BELTS (1/5)

Always wear your seat belt when trav-

elling in your vehicle. You must also

comply with the legislation of the par-

ticular country you are in.

Before starting, first adjust your driv-

ing position, then ask all occupants

to adjust their seat belts to ensure

optimum protection.

Adjusting your driving

position

– Sit well back in your seat (having

removed your coat or jacket etc.).

This is essential to ensure your back

is positioned correctly;

Make sure that the rear bench seat

is locked in position correctly so that

the rear seat belts will operate cor-

rectly. ➥ 3.24.

– adjust the distance between the

seat and the pedals. Your seat

should be as far back as possible

while still allowing you to fully de-

press the pedals. The seatback

should be adjusted so that your arms

are slightly bent when you hold the

steering wheel;

Adjusting the seat belts

Sit with your back firmly against the

seatback.

Incorrectly adjusted or

twisted seat belts may

cause injuries in the event

of an accident.

The shoulder strap 1 should be as close

as possible to the base of the neck but

not on it.

– adjust the position of the steering

wheel.

Use one seat belt per person,

whether child or adult.

Lap belt 2 should be worn flat over the

thighs and against the pelvis.

Even pregnant women should wear

a seat belt. In this case, ensure that

the lap belt is not exerting too much

pressure on the abdomen, but do

not allow any slack.

The seat belt must be worn as close to

the body as possible. Eg: avoid wearing

heavy clothing or keeping bulky objects

under the belts, etc.

1.41

SEAT BELTS (2/5)

Depending on the vehicle, if the seat is

occupied and one of the seat belts is

not fastened or becomes unfastened

while the vehicle is moving at a speed

over approximately 12 mph (20 km/h),

the

™

warning light flashes and a

beep sounds for 120 seconds.

Note: an object placed on the passen-

ger seat base may, in some cases, ac-

tivate the warning light and an audible

warning.

Locking

Unlocking

Unwind the belt slowly and smoothly

and ensure that buckle 3 locks into

catch 5 (check that it is locked by pull-

ing on buckle 3). If the belt jams, allow

it to return slightly before attempting to

unwind it again.

Press button 4 and the seat belt will be

rewound by the inertia reel. Guide the

belt.

Driver’s seat belt reminder

and, depending on the vehi-

cle, front passenger seat belt re-

minder

™

If your seat belt is completely jammed,

pull slowly, but firmly, so that just over

3 cm unwinds. Allow it to return slightly

before attempting to unwind it again.

This appears on the central display 6

when the ignition is switched on and

if the driver’s and/or front passenger’s

seat belt(s) (if the passenger seat is oc-

cupied) is not fastened.

If there is still a problem, contact an ap-

proved dealer.

1.42

SEAT BELTS (3/5)

Understanding the graphic 7:

– indicator green: seatbelt fastened;

– indicator red: seatbelt unfastened.

When the vehicle speed is below ap-

proximately 12 mph (20 km/h), the

graphic 7 appears during approxi-

mately 60 seconds every time one of

the rear seat belts is fastened or unfas-

tened.

When the vehicle speed reaches or ex-

ceeds 12 mph (20 km/h), if one of the

rear seat belts is unfastened during the

journey:

– the

the central display;

and

– a beep sounds for around 30 sec-

onds;

™

warning light flashes on

Rear seat belt reminder

(depending on the vehicle)

Adjusting the height of the

front seat belts

The graphic 7 appears on the in-

strument panel when the ignition is

switched on.

This informs the driver of the fasten-

ing status of each of the rear seat belts

every time:

Press the button 8 to adjust the seat

belt height, so that the shoulder strap 1

is worn as shown previously. Press

button 8 and raise or lower the seat

belt. Make sure that the seat belt is

locked in position correctly after you

have adjusted it.

and

– the 7 symbol is displayed for at least

60 seconds and the symbol for the

seat concerned changes to red.

In all cases, ensure that all rear pas-

sengers are wearing seat belts and

that the number of seat belts shown as

fastened matches the number of rear

seats occupied.

– the ignition is switched on;

– opening a door;

– a rear seat belt is fastened or unfas-

tened.

1.43

SEAT BELTS (4/5)

Fasten sliding buckle 12 into the corre-

sponding red catch 14.

Rear side seat belts 9

The belts are locked, unlocked and

adjusted in the same way as the front

belts.

Rear centre seat belt

Unwind belt 10 slowly from its housing,

then fasten buckle 11 into the corre-

sponding black catch 13.

Check that the rear seat

belts are positioned and

operating correctly each

time the rear bench seat is

moved.

1.44

SEAT BELTS (5/5)

The following information applies to the vehicle’s front and rear seat belts.

– No modification may be made to the component parts of the originally fitted restraint system: seat belts, seats and

their mountings. For special operations (e.g. fitting child seats), contact an authorised dealer.

– Do not use devices which allow any slack in the belts (e.g. clothes pegs, clips, etc.): a seat belt which is worn too

loosely may cause injury in the event of an accident.

– Never wear the shoulder strap under your arm or behind your back.

– Never use the same belt for more than one person and never hold a baby or child on your lap with your seat belt around

them.

– The belt should never be twisted.

– Following an accident, have the seat belts checked and replaced if necessary. Always replace your seat belts as soon as

they show any signs of wear.

– When the rear bench seat is being put back, make sure that the seat belts and buckles are correctly positioned so that they

can be used properly.

– Make sure that the buckle is inserted into the appropriate catch.

– Ensure that no objects are placed in the area around the seat belt catch as they could prevent it from being properly se-

cured.

– Make sure the seat belt catch is properly positioned (it should not be hidden away, crushed or flattened by people or ob-

jects).

1.45

Getting to know your vehicle -> Seat belts for Your Renault Zoe 4 Door Third Generation (2019-2024)

Related Topics

Popular Owner Manuals

Latest Owner Manuals