Get Instruments and controls -> Information display (if equipped) Guide for Subaru XV SUV First Generation (2010-2016)

3-23

Instruments and controls/Information display

& Outside temperature indica-

Information display (if

! Road surface freeze warning indi-

tor

cation

equipped)

NOTE

For models with color multi function

display, refer to “Multi function dis-

play” F3-28.

U.S.-spec. models

Except U.S.-spec. models

When the outside temperature drops to

The outside temperature indicator shows

378F (38C) or lower, the temperature

the outside temperature in a range from

indication flashes to show that the road

−40 to 1228F (−40 to 508C).

surface may be frozen.

Outside temperature indicator

The indicator can give a false reading

If the outside temperature drops to 378F

Driving information display

under any of the following conditions.

(38C) or lower while the display is giving

Clock

. When there is too much sun.

an indication other than the outside

With the ignition switch in the “ACC”

. During idling; while running at low

temperature, the display switches to the

position, the clock appears on the display.

speeds in a traffic jam; when the engine

outside temperature indication and flashes

is restarted immediately following a shut-

for 5 seconds before returning to its

With the ignition switch in the “ON”

down.

original indication.

position, the outside temperature indica-

. When the actual outside temperature

If the display is already indicating an

tor, driving information display and clock

falls outside the specified indicator range.

outside temperature of 378F (38C) or lower

all appear on the display.

when the ignition switch is turned to the

– CONTINUED –

3-24 Instruments and controls/Information display

“ON” position, the indication does not

sequence.

! Driving range on remaining fuel

flash.

NOTE

The outside temperature indication

may differ from the actual outside

temperature. The road surface freeze

warning indication should be treated

only as a guide. Be sure to check the

condition of the road surface before

driving.

& Driving information display

U.S.-spec. models

Except U.S.-spec. models

The driving range indicates the distance

that can be driven taking into account the

amount of fuel remaining in the tank and

the average rate of fuel consumption.

When the low fuel warning light illumi-

nates, the driving range display flashes for

5 seconds. (The display first switches to

the driving range value if a different value

was previously displayed.)

Information display selection knob

With the ignition switch in the “ON”

position, each successive press of the

information display selection knob

switches the display in the following

3-25

Instruments and controls/Information display

! Average fuel consumption

U.S.-spec. models

Trip knob

Except U.S.-spec. models

U.S.-spec. models

Pressing the trip knob toggles the display

Except U.S.-spec. models

If the driving range is shown as “

”,

between the average fuel consumption

there is only a tiny amount of fuel left in the

corresponding to the A trip meter display

This display shows the average rate of

tank. You must refuel the vehicle immedi-

and the average fuel consumption corre-

fuel consumption since the trip meter was

ately.

sponding to the B trip meter display.

last reset.

When either of the trip meter displays is

NOTE

reset, the corresponding average fuel

The driving range on remaining fuel is

consumption value is also reset.

only a guide. The indicated value may

NOTE

differ from the actual driving range on

remaining fuel, so you must immedi-

. The indicated values vary in accor-

ately fill the tank when the low fuel

dance with changes in the vehicle’s

warning light illuminates.

running conditions. Also, the indicated

values may differ slightly from the

actual values and should thus be

treated only as a guide.

. When either trip meter display is

reset, the average fuel consumption

– CONTINUED –

3-26 Instruments and controls/Information display

corresponding to that trip meter dis-

display is giving a reading other than the

! Journey time

play is not shown until the vehicle has

journey time, the display switches to the

subsequently covered a distance of 1

journey time, flashes for 5 seconds, and

mile (or 1 km).

returns to its original reading each time a

complete hour has elapsed.

! Current fuel consumption

NOTE

The journey time is reset when the

ignition switch is turned to the “LOCK”

(off) position. It is also reset if the

ignition switch is turned to the “LOCK”

(off) or “ACC” position prior to restart-

ing of the engine.

! Average vehicle speed

The journey time shows the time that has

elapsed since the ignition switch was

turned to the “ON” position.

U.S.-spec. models

Except U.S.-spec. models

This indication shows the rate of fuel

consumption at the present moment.

U.S.-spec. models

Except U.S.-spec. models

This display shows the average vehicle

The journey time indication flashes each

speed since the trip meter was last reset.

time a complete hour has elapsed. If the

3-27

Instruments and controls/Information display

& Clock

! Turn off display of driving informa-

tion display

The driving information display can be

turned off.

To turn off the display, turn the ignition

switch to the “LOCK” (off) position and

press the “+” button adjacent to the clock

display for approximately 5 seconds.

Then, the driving information display and

the clock display will blink for 3 seconds to

notify you that the driving information

display has been turned off.

To restore the driving information display,

Trip knob

once again press the “+” button for

approximately 5 seconds.

Pressing the trip knob toggles the display

To adjust the time shown by the clock,

between the average vehicle speed cor-

press the “+” button or “−” button. If you

NOTE

responding to the A trip meter display and

press the “+” button, the indicated time will

. The initial display setting of the

the average vehicle speed corresponding

change in one-minute increments. If you

driving information display has been

to the B trip meter display.

press the “−” button, the indicated time will

set to operational at the time of ship-

change in one-minute decrements. If you

When either of the trip meter displays is

ment from the factory.

keep the button pressed, the rate at which

reset, the corresponding average vehicle

. The average fuel consumption and

the indicated time changes will speed up.

speed value is also reset.

average vehicle speed are calculated

The clock can be set to 12-hour or 24-hour

NOTE

even while the driving information dis-

clock displays. Perform the following

play is not displayed.

When either trip meter display is reset,

procedure to switch the display format.

. Even if you turn off the driving

the average vehicle speed correspond-

1. Place the ignition switch in the “LOCK”

information display, the display will

ing to that trip meter display is not

(off) position.

automatically turn on when the battery

shown until the vehicle has subse-

voltage is disconnected and then re-

2. Press and hold the “−” button that is

quently covered a distance of 1 mile

connected for battery replacement or

located near the clock display for approxi-

(or 1 km).

fuse replacement.

mately 5 seconds. The clock display will

then start to flash.

– CONTINUED –

$3-28 Instruments and controls/Multi function display3. While the clock display is flashing,& Safety precautionsMulti function displaypress and hold the “+” button for approxi-mately 2 seconds. The clock format will& Models without multi func-WARNINGthen displayAlways pay adequate attention to4. The clock display will continue to flashNOTEsafe driving when operating thefor approximately 3 seconds to inform you. For models with information displaymulti function display while thethat the clock display has been changed.(black and white), refer to “Informationvehicle is in motion. When operationIf you want to change the clock displaydisplay” the multi-function display is dis-again, press and hold the “+” button for. When the vehicle is in motion,turbing your awareness and abilityapproximately 2 seconds while the clockcertain functions and selections mayto concentrate on driving, stop thedisplay is be in a safe place before per-forming operations on the U.S.-spec models are not equippedAlso, do not concentrate on thewith the multi function display. The otherdisplay while driving. Doing so maymodels may be equipped with the multicause you to look away from thefunction display or not, depending on theroad and could result in an .$

3-28 Instruments and controls/Multi function display

3. While the clock display is flashing,

& Safety precautions

Multi function display

press and hold the “+” button for approxi-

mately 2 seconds. The clock format will

& Models without multi func-

WARNING

then change.

tion display

Always pay adequate attention to

4. The clock display will continue to flash

NOTE

safe driving when operating the

for approximately 3 seconds to inform you

. For models with information display

multi function display while the

that the clock display has been changed.

(black and white), refer to “Information

vehicle is in motion. When operation

If you want to change the clock display

display” F3-23.

of the multi-function display is dis-

again, press and hold the “+” button for

. When the vehicle is in motion,

turbing your awareness and ability

approximately 2 seconds while the clock

certain functions and selections may

to concentrate on driving, stop the

display is flashing.

not be available.

vehicle in a safe place before per-

forming operations on the screen.

The U.S.-spec models are not equipped

Also, do not concentrate on the

with the multi function display. The other

display while driving. Doing so may

models may be equipped with the multi

cause you to look away from the

function display or not, depending on the

road and could result in an accident.

model.

Instruments and controls -> Information display (if equipped) for Your Subaru XV SUV First Generation (2010-2016)

Related Topics

Popular Owner Manuals

Latest Owner Manuals