3-6 Instruments and controls/Meters and gauges
& Canceling the function for
trip knob.
& Speedometer
meter/gauge needle move-
The speedometer shows the vehicle
ment upon turning on the
speed.
ignition switch
& Odometer
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the “ON”
*: They cannot be displayed when the
position. To change the setting, perform
ignition switch is in the “ON” position.
the following procedure.
To change the current setting, press the
1. Turn the ignition switch to the “LOCK”
trip knob for at least 2 seconds.
(off) or “ACC” position.
: Activated
: Deactivated
NOTE
. Your vehicle’s initial movement
setting of the meter/gauge needles
1)
Trip knob
has been set for activation “ ” at
This meter displays the odometer when
the time of shipment from the factory.
the ignition switch is in the “ON” position.
. It is not possible to change the initial
movement setting of the meter/gauge
The odometer shows the total distance
needles when the ignition switch is in
that the vehicle has been driven.
the “ON” position. Change the setting
If you press the trip knob when the ignition
when the ignition switch is in the
switch is in the “LOCK” (off) or “ACC”
1)
Trip knob
“LOCK” (off) or “ACC” position.
position, the odometer/trip meter will light
2. Press the trip knob to show “
” or
up. If you do not press the trip knob within
“ ” on the trip meter display.
10 seconds of illumination of the od-
ometer/trip meter, the odometer/trip meter
The display can be switched as shown in
will turn off.
the following sequence by pressing the
English 
