3-73
Instruments and controls/Turn signal lever
& Daytime running light system
level, the high beam headlights that
Turn signal lever
have illuminated at reduced brightness
turn off, and the low beam headlights
WARNING
turn on alternatively. At this time, the
instrument panel illumination, front
The brightness of the illumination of
side marker lights, tail lights and
the high beam headlights is reduced
license plate lights are also illuminated.
by the daytime running light system.
The light switch must always be
turned to the “ ” position when it
is dark outside.
The high beam headlights will automati-
cally illuminate at reduced brightness
when the following conditions are fulfilled.
. The engine is running.
. The parking brake is fully released.
To activate the right turn signal, push the
. The light control switch is in the
turn signal lever up. To activate the left
“AUTO” (if equipped), “
” or off position.
turn signal, push the turn signal lever
. For CVT models, the select lever is in a
down. When the turn is finished, the lever
position other than the “P” position.
will return automatically. If the lever does
not return after cornering, return the lever
NOTE
to the neutral position by hand.
. When the light switch is in the “
”
To signal a lane change, push the turn
position, the instrument panel illumina-
signal lever up or down slightly and hold it
tion, front side marker lights, tail lights
during the lane change. The turn signal
and license plate lights are also illumi-
indicator lights will flash in the direction of
nated.
the turn or lane change. The lever will
. For models with the auto on/off
return automatically to the neutral position
headlights, while the light control
when you release it.
switch is in the “AUTO” position and
the system is activated to the auto-on
mode depending on the ambient light
English 
