2024-2026 Cupra Terramar SUV Driving -> Starting and stopping the engine. User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Driving -> Starting and stopping the engine. for Your Cupra Terramar SUV First Generation (2024-2026)

166
Driving
Due to the dierent technical standards that
exist, it may not be possible to charge the
high-voltage battery at charging stations in
other countries, or it may only be possible with
a suitable charging cable. You can get more
information from a specialised CUPRA dealer
or any SEAT network dealer.
WARNING
As altitude increases, air density decreases.
Due to the reduced air density, engine per-
formance may be reduced and vehicle com-
ponents may be damaged during prolonged
operation at very high altitudes. Reduced en-
gine power can lead to accidents and serious
or fatal injuries, e.g. when overtaking.
●
Before travelling abroad, especially at alti-
tudes above 3,000m (approx. 9,843ft) above
sea level, please contact a specialised CUPRA
dealer or any dealer in the SEAT network for
more information.
NOTICE
●
CUPRA cannot be held liable for any dam-
age to the vehicle due to insuicient work or
lack of availability of genuine spare parts.
●
CUPRA accepts no liability if the vehicle
does not meet the legal requirements in
force in other countries and continents, or
if it only partially meets them.
Starting and stopping the
engine.
Switching the ignition on/o
Fig.115 On the steering wheel: start
button.
The engine can be started with a start button
(Press & Drive). For this there must be a valid
key inside the vehicle interior.
Opening the driver's door when exiting the ve-
hicle activates the electronic lock on the steer-
ing column if the ignition is switched o. For
vehicles with automatic transmission, the col-
umn will only be locked if the parking lock P is
activated.
Switching the ignition on/o
If you only want to switch on the ignition (with-
out starting the engine):
●
Vehicles with automatic gearbox: briey
press the start button once without pressing
the brake pedal ››› .
Automatic ignition disconnection
When the vehicle detects that there is no
driver once the engine has stopped, after a
certain time the ignition is switched o au-
tomatically. If at that time the dipped beam
headlights are on, the side lights will stay on
for approx. 30 minutes. The side lights can be
turned o by locking the vehicle ›››page106,
or manually ›››page131.
Automatic deactivation of the ignition on
vehicles with the Start-Stop system
The ignition is switched o automatically when
the vehicle is stopped and the automatic en-
gine shutdown is active, if:
●
the driver's seat belt is not fastened,
●
the driver does not step on any pedal,
●
the driver's door is opened.
After automatically turning o the ignition, if
the dipped beam is on, the side light re-
mains on for approx. 30 minutes (if the battery
has enough charge). If the driver locks the ve-
hicle or manually turns o the light, the side
light goes out.
Driving
167
Starting and stopping the engine.
Switching o the ignition when leaving the
vehicle, with hybrid drive
When the ignition is not switched o in E-
MODE operating mode, a certain amount of
time after the journey is complete it switches
o automatically to prevent draining the 12-
volt vehicle battery.
Breath alcohol ignition interlock device
(breathalyser)
The vehicle is ready for the installation of
a breath alcohol ignition interlock device
(breathalyser with LIN communication).
After installing a breath alcohol ignition inter-
lock device, it will always be necessary to pass
a breathalyser test before the ignition can be
switched on.
Some vehicle functionalities may be limited.
WARNING
When switching on the ignition, do not press
the brake pedal, otherwise the engine could
start immediately.
WARNING
If vehicle keys are used negligently or without
due care, this may cause accidents and seri-
ous injury.
●
Never leave any key inside the vehicle
when you leave it. Otherwise, a child or unau-
thorised person could lock the vehicle, start
the engine or connect the ignition and oper-
ate any of the electrical equipment.
Note
●
Before leaving the vehicle, always discon-
nect the ignition and, if appropriate, take into
account the instructions on the dash panel
screen.
●
If the vehicle is stationary for a long time
with the engine o and the ignition on, the
vehicle battery might be discharged and it
might not be possible to start the engine.
●
If during the STOP phase you press the
button, the ignition is switched
o.
Starting the engine
●
Vehicles with automatic transmission: press
the brake pedal and keep it pressed in this po-
sition until the engine starts.
●
Press the start button without pressing the
accelerator. There must be a valid key in the
vehicle for the engine to start.
●
If the engine does not start, stop and wait
for around 1 minute to try again. If necessary,
perform an emergency start ›››page169.
WARNING
Do not keep the engine running in conned
spaces, as there is a risk of poisoning.
●
The exhaust gases contain carbon monox-
ide, an odourless and colourless poisonous
gas that can cause loss of consciousness and
death.
WARNING
Do not get out of the vehicle with the engine
running, especially if a gear is engaged. The
vehicle could then suddenly move or some-
thing strange could happen that would cause
damage, re or serious injury.
WARNING
Never use cold start sprays, they could ex-
plode or cause the engine to run at high revs.
Doing this risks injury.
168
Driving
NOTICE
●
The starter motor or the engine may be
damaged if you try to restart the engine im-
mediately after switching it o.
●
When the engine is cold, you should avoid
high engine speeds, driving at full throttle
and over-loading the engine, as this could
cause engine damage.
For the sake of the environment
Do not warm-up the engine by running the
engine with the vehicle stationary. Start o
immediately, driving gently. This helps the
engine reach operating temperature faster
and reduces emissions.
Note
Electrical components with a high power
consumption are switched o temporarily
when the engine starts.
●
When starting with a cold engine, noise
levels may briey increase. This is quite nor-
mal, and no cause for concern.
Turning o the engine
●
Bring the vehicle to a full stop ››› .
●
Vehicles with an automatic gearbox: Switch
on the parking lock by pressing button P.
●
Apply the electronic parking brake.
●
Briey press the start button.
Car wash function (hybrid vehicles)
When the ignition is turned o with gear N ac-
tivated, the vehicle can roll for the next 30 mi-
nutes. After that time, if the vehicle is stopped
the parking lock P activates automatically. The
corresponding warning message is displayed
on the instrument cluster display one minute
before this happens.
WARNING
Never switch o the engine while the vehicle
is in motion. This could cause loss of control
of the vehicle, accidents and serious injury.
●
The airbags and seatbelt pretensioners do
not work when the ignition is switched o.
●
The brake servo does not work when the
engine is switched o. Therefore, when the
engine is switched o, the brake pedal has to
be pressed harder to stop the vehicle.
●
The power steering does not work when
the engine is switched o. When the engine
is switched o, more force is required to turn
the steering wheel.
●
If the ignition is switched o, the steering
column lock may activate, leaving the vehicle
impossible to control.
WARNING
Always take the key with you when leaving
the vehicle. This is particularly important if
there are children in the vehicle, as they
might otherwise be able to start the engine
or use power-operated equipment (e.g. the
electric windows), which could cause injuries.
NOTICE
●
If the vehicle is stopped and the Start-Stop
system switches o the engine, the ignition
remains switched on. Before leaving the ve-
hicle, make sure that the ignition is switched
o, otherwise the battery will discharge.
●
If the engine has been driven at high speed
for a prolonged period of time, it may over-
heat when switched o. To avoid damage, al-
low the engine to run for approximately two
minutes in neutral before switching it o.
Note
After stopping the engine, the radiator fan
may continue to run for up to 10 minutes,
even with the ignition switched o. It may
also start up again if the coolant tempera-
ture rises due to heat building-up under the
engine compartment or if the engine gets
even hotter due to prolonged exposure to
sunlight.
Driving
169
Starting and stopping the engine.
Electronic immobilizer
The electronic immobiliser helps to prevent
the engine from being started with an unau-
thorised key and, consequently, the vehicle
being put in motion.
The vehicle key has an integrated chip which
automatically deactivates the electronic im-
mobiliser if there is a valid key inside the vehi-
cle interior.
The electronic immobiliser is automatically ac-
tivated when there is no longer a valid key in-
side the vehicle.
For this reason, the engine can only be star-
ted with a correctly coded Original CUPRA key.
This type of key can be purchased from a spe-
cialised CUPRA dealer or any SEAT network
dealer.
NOTICE
The correct operation of the vehicle is only
guaranteed with original CUPRA keys.
Emergency starting function
Fig.116 On the centre console: emergency
start.
If no valid key is detected inside the vehicle,
an emergency start-up will be required. The
relevant message will appear in the dash panel
display. This may happen when, for example,
the vehicle key battery is very low.
●
Immediately after pushing the start button,
place the key in the drink holder of the centre
console ›››Fig.116, as close as possible to the
Kessy logo.
●
The ignition connects and the engine starts
automatically.
Indications for the driver on the in-
strument cluster display
Press the brake
●
This message appears on vehicles with an
automatic gearbox if the driver tries to start the
engine without pressing the brake pedal.
Press the brake to engage a gear
●
This indication is displayed when starting or
stopping the engine if the automatic transmis-
sion selector lever is in position D or R and the
brake pedal is not depressed. The engine can
only be started and stopped in these positions.
Engage position P; the vehicle can move;
doors can only be locked in position P.
●
For safety reasons, this driver message ap-
pears and an audible warning sounds if the
parking lock button P is not pressed after
switching o the engine. Press button P other-
wise the vehicle could move.
Ignition is switched on
●
This driver message is displayed and a buz-
zer sounds when the driver's door is opened
with the ignition switched on.

Related Topics

Popular Owner Manuals